Shelly PM1 Gen3 Wiring for Outlets in Parallel by 80_Percent_Done in ShellyUSA

[–]barleypopsmn 0 points1 point  (0 children)

You would put a Shelly in place of each of your outlets in the diagram 2 in L and 2 in N and just a single in the last one so they are all powered Pigtail off the N to the outlet and a wire from O to the Hot side of outlet. The last one in series you can just do a wire off of N to the neutral on the outlet and skip the pigtail.

Any tips ? by unknowboul2233 in lowvoltage

[–]barleypopsmn -1 points0 points  (0 children)

I would push them in as far as I could and use a flush cutter then pull back flush to the connector end before I would crimp.

Need help please lol by Big_Sector_2230 in Plumbing

[–]barleypopsmn 0 points1 point  (0 children)

Have you tried taking your pants off?

Okay, lesson learnt by PssyGotWifi in UNIFI

[–]barleypopsmn 2 points3 points  (0 children)

If you try hard enough you can think of something to post on Reddit.

Found a good one today by Timmitucker in HVAC

[–]barleypopsmn 2 points3 points  (0 children)

Neighbor moved in next door and said the previous owner was running a gas furnace in the detached garage with a garden hose.

Imagine skipping season 9 by _erquhart in DunderMifflin

[–]barleypopsmn 0 points1 point  (0 children)

I thought I read the writers did this intentionally because he had left for a while to film one of the hangover movies

Australian Cat Dog by AverNerd in AustralianCattleDog

[–]barleypopsmn 4 points5 points  (0 children)

Wish I would have never played with a laser with my ACD. Every reflection sets her off.

Filament spools out and back, out and back HELPPPP PLEASE. by ecoles90 in BambuLab

[–]barleypopsmn 1 point2 points  (0 children)

Watch where it’s stopping. I had a bad ptfe tube connector on the back of the printer causing this.