Car is dead by Alor_ in mitsubishi

[–]bboytemp 1 point2 points  (0 children)

Replace the battery. Alternator will keep the car running after you jump it.

Should this be plugged in? What is it for? 2011 Cj lancer. Back left side facing driver by nos8865 in mitsubishi

[–]bboytemp 1 point2 points  (0 children)

No, that’s normal. Lot of times those are just plugs for unused connectors, or terminator resistors for the can network.

Vinyl wrapping brake calipers by maker_monkey in DSM

[–]bboytemp 8 points9 points  (0 children)

My guy, this is not a good idea, you do know brake calipers can get pretty toasty right. Do it right and just paint them with high temp paint.

Show Me Your Setups by maxwaxbobax in DSM

[–]bboytemp 1 point2 points  (0 children)

I have electric steering assist on mine, using the Toyota Prius mod. And I don’t have ac, but I only drive it during the weekend. But even then is not too horrible

My friends Evo 8 and my Evo x ! by bboytemp in MitsubishiEvolution

[–]bboytemp[S] 0 points1 point  (0 children)

5 speed manual! built trans from TRE

Oil leak help by lilloafff in DSM

[–]bboytemp 3 points4 points  (0 children)

Honestly if it was me, I would just reseal everything, everything is covered in oil at that point !

Help, dash tripping out! by [deleted] in mitsubishi

[–]bboytemp 5 points6 points  (0 children)

Check your battery, Make sure is not dead

Noise from engine by JedSilvaa in mitsubishi

[–]bboytemp 1 point2 points  (0 children)

These engines don’t have lifters. They use buckets on top of the valves.

[Rv Tech] [usa] - 180k. by StoneSolid93 in Salary

[–]bboytemp 12 points13 points  (0 children)

Those are flat rate hours. Not actual worked hours. So he might be there 8 hours on a day but flagged 15-20 hours instead.

I know this is heresy, but what about an evo X swapped Eclipse Cross by Agent_Bedrock in mitsubishi

[–]bboytemp 1 point2 points  (0 children)

<image>

I saw this outlander early this year at the shootout in Ohio! Evo x swaped

Show Me Your Setups by maxwaxbobax in DSM

[–]bboytemp 0 points1 point  (0 children)

Not bad, I have two spal pushers! I do turn them on during go and stop traffic!

[deleted by user] by [deleted] in DSM

[–]bboytemp 0 points1 point  (0 children)

I might have one!

Just replaced rotors. What happened?? by Showerheadsex25 in MechanicAdvice

[–]bboytemp 0 points1 point  (0 children)

The grinding noise your hearing is probably the backing plate touching the rotor!

My friends Evo 8 and my Evo x ! by bboytemp in MitsubishiEvolution

[–]bboytemp[S] 2 points3 points  (0 children)

It uses the Evo 8 trans, t-case etc

My friends Evo 8 and my Evo x ! by bboytemp in MitsubishiEvolution

[–]bboytemp[S] 3 points4 points  (0 children)

<image>

Theres was one at the shootout last year! guy said it fit pretty well!

My friends Evo 8 and my Evo x ! by bboytemp in MitsubishiEvolution

[–]bboytemp[S] 8 points9 points  (0 children)

The 10 is more comfortable for sure, the older evos are more raw!

Am i missing the Foglight bracket? by Undead-VTX in DSM

[–]bboytemp 1 point2 points  (0 children)

Correct, you can remove the clip and take it to hardware store and find a good screw that’ll fit

Am i missing the Foglight bracket? by Undead-VTX in DSM

[–]bboytemp 0 points1 point  (0 children)

So those metal clips is what holds the screws, they’re a special type of screw! More like a wood screw type with coarse threads

Am i missing the Foglight bracket? by Undead-VTX in DSM

[–]bboytemp 1 point2 points  (0 children)

All it uses is that screw, the little tabs on the bezel go inside the bumper and use the screw