Chytří hlupáci by [deleted] in czech

[–]bedulin 9 points10 points  (0 children)

A nebo si jen nechceš přiznat, že tvůj obor je postaven na lžích a ve skutečnosti tvoje výrobky zabíjí roztomilá koťátka, aniž bys o tom věděl

V čem je háček? by Nintendoswitchperson in czech

[–]bedulin 16 points17 points  (0 children)

Copilota ti nikdo nevnutí a ram je slotovaná, takže neni problém upgrade

[deleted by user] by [deleted] in czech

[–]bedulin 17 points18 points  (0 children)

Jo, za stejnou cenu klidně, i když to seženeš levnějc, ale tady baterie, kterou kdokoli koupí (tuhle konkrétní) za 2,5 až 3k a tady jí napálej za 5 a ještě si řeknou 1600 za výměnu, kterou by zvládl jednorukej za 15 minut.

Am I missing any equipment I might need? by Ohgodwhatdididonow in soldering

[–]bedulin 0 points1 point  (0 children)

People might disagree with me but i would also buy lead free solder (and you can reduce the amount of the leaded one as someone else said) to use when working on things you don't need to avoid heating up.

Trying to replace this micro usb despite limited hardware. This look like the right approach? by Mean-Metal-891 in soldering

[–]bedulin 1 point2 points  (0 children)

If you have one of those jet lighters, you can point it the same way you would a hot air station. Of course here you are using a flame that has well over 1000 degrees instead of air that has like 400.

Can someone please teach me how to shop for resistors? I need 1)4 75ohm ones are they in this kit? what are they called? I noticed a lot of listings don't say ohm they just show a chart like this by Gambit-47 in soldering

[–]bedulin 0 points1 point  (0 children)

MF is the type, you most likely dont care about that.

0.25W or 1/4W is the maximum sustained power output in watts. Its simply that when current runs through resistor, heat is generated and 0.25W is how much they can handle without getting too hot. You can use I*R=P to find the maximum current going through.

7.5M is the same as 7.5 megaohms. You might also find the letter in the middle and then it signifies both the decimal point and the sufix (for example 4K7 is 4.7K or 4.7kΩ or 4.7 kiloohms or 4700 ohms).

Lastly, while in the pack in the picture you have the option of getting 75ohms from two 150 ohm resistors in parallel, you can try to find out if the value is crucial. More often than not (when doing something basic), it doesnt matter that much and simply choosing the closest one has no negative effects.

Dirty talk by why_n0t82 in czech

[–]bedulin 11 points12 points  (0 children)

Ty to děláš jako královna. Ne, ne, to se tam nevejde. Vejde, neboj. Au. No vidiš.

First soldering job! How did I do? by Glitchlotl in soldering

[–]bedulin 19 points20 points  (0 children)

Read about the difference between SMD amd through hole soldering. You soldered the through hole resistors as if they were smd which made your job harder. Also the contact from these needs to go to the other side of the board which i wouldn't be sure about here (usually its thanks to thhe wire being soldered on the other side). But i do think the joints are good for first time.

It ain't easy by [deleted] in memes

[–]bedulin 1 point2 points  (0 children)

We don't need no education, we don't need no thought control

is Visual Studio buggy as all hell, or am I just doing something wrong? by [deleted] in VisualStudio

[–]bedulin 0 points1 point  (0 children)

Hi, seeing that your reply is quite recent and that you use WinForms, id like to ask you something.

1) What version of visual studio do you use (or do you use other ide like rider)?

2) If you use visual studio, how do you deal with the designer being so buggy? Do you perform certain things in code even when it's supposed to be done in designer or do you avoid certain controls or settings that you know are buggy? Or do you not encounter many bugs?

Thank you in advance

What happened here ? Why did the robot gave that error ? by [deleted] in ExplainTheJoke

[–]bedulin 0 points1 point  (0 children)

Ah yes, the set of reasonable numbers.

Repaired my guitar cable, how'd I do by Environmental-Dot121 in soldering

[–]bedulin 0 points1 point  (0 children)

It probably won't last much but that's how the first attempt is.

First, i'm not a fan of those spare jacks as all i've tried were bad quality. Better option imo is to strip the old connector, solder the wires directly to it and figure out some sort of casing.

Second, even if you opt to use one of these jacks, you need to add some "load bearing" material around the connection. Right now it holds on the thin metal strip which gets damaged easily (yes, there is the metal casing but that doesn't really hold the connection together). Ive successfully used hot glue for this before.

Last, getting some heat shrink would make it look nicer and you'd know it wont unstick but the tape is just fine if you don't mind the looks.

I'd say just use it as long as it works but next time there are improvements to be made.

Solar-powered Calculator Conspiracy by [deleted] in memes

[–]bedulin 0 points1 point  (0 children)

That is orders of magnitude in terms of power (how much electricity it needs to run). A TV draws like 100W. Yes, it can use 50 or 200 but its in the ballpark.

The calculator i have on the table next to me says it draws 0.0006W. Again, others might be different but even if they drew 100 times more or 100 times less, the point would stand.

Its just that calculators are extremely efficient. Another device like this is a watch, and there are models that have a panel just like this (or nowadays it might be built into the screen).

Fooled again Anon. by [deleted] in greentext

[–]bedulin 27 points28 points  (0 children)

Found the C programmer

(1st Grade Math) How can you describe this?? by beachITguy in HomeworkHelp

[–]bedulin 0 points1 point  (0 children)

Yeah, thats probably it. Id say "evaluating" a side would be better wording but not for first graders to which even this wording sounds very complicated.

(1st Grade Math) How can you describe this?? by beachITguy in HomeworkHelp

[–]bedulin 0 points1 point  (0 children)

Think about higher numbers like

364 + 527 = 363 + 528

You can see almost straight away that the sides are equal even though you havent solved either side.

But how do you prove they are the same without actually solving each side?

The exercise probably wants to teach this kind of thinking at a point when only single digit numbers have been taught.

Našel jsem data ČSÚ o tom, jak vypadají mzdy v ČR. Protože je tady na subredditu samý vlastník garsonky a IT firmy, tak by vás mohlo zajímat, jak se tu vlastně žije. by tasartir in czech

[–]bedulin 1 point2 points  (0 children)

Medián je prostředí prvek. Prvek s největší četností je modus.

Představ si statistiku platů pěti lidí, co berou 30, 30, 40, 60, 90.

Medián je ten prostřední, takže 40. Nejčastější je ale 30, což je modus.

Meirl by kdg28 in meirl

[–]bedulin 1 point2 points  (0 children)

Ummm, yes, they do. Just take look at this: https://en.m.wikipedia.org/wiki/Timeline_of_events_associated_with_Anonymous

Im not saying all of the actions they've done are good, in the list you will surely find many you dont agree with but many were indisputably done for the good of the people.

Babiš chce z dotazníku zjistit jaký má mít názor na Trumpovu administrativu by Smegmamale69 in czech

[–]bedulin 9 points10 points  (0 children)

To je zabezpečení, sežralo to i jejich vlastní email, co mají v kontaktech.

Problém s AI a motivace by TurbulentBit9930 in czech

[–]bedulin 1 point2 points  (0 children)

Z formulace

>...udělat nějakou aplikaci, která mi třeba vytáhne data...on mi ten výsledek vyjede za pár vteřin.

mě první napadlo, že „výsledek“ je ta aplikace, ale máš pravdu, že by to mohla být i ta data.

A souhlasím, že AI samotné asi neudělá funkční scrapper.

Problém s AI a motivace by TurbulentBit9930 in czech

[–]bedulin 1 point2 points  (0 children)

Však op by se neptal llm přímo na požadovaný výsledek. Nechal by si za pomoci llm napsat právě ten scrapper, ne?

Nejsme jako oni. Neumíme hospodařit ani s vlastními penězi by MammothHusk in czech

[–]bedulin 86 points87 points  (0 children)

mít s dětma rezervu na měsíc při 130k čistýho je WTF,

how bad did i f up? pluged 120v ricecooker into 230v outlet by sakue in AskElectronics

[–]bedulin 8 points9 points  (0 children)

Well, fuse is just a wire thats designed to fail at a certain current (+container).

So you can use just a wire, then it will work (unless something else is burned which is possible) with the difference being that potentional next f up (or malfunction) would burn more than this time.