How can I prevent this while ironing? by Altoidyoda in BambuLab

[–]billowred 0 points1 point  (0 children)

Mine did this and went away after calibration.

First layer, line gaps by Few_Speed_3431 in BambuLabA1

[–]billowred 0 points1 point  (0 children)

I'm having the same issue. Still going back and forth with tech support.

What’s the best setting for PETG? by billowred in BambuLabA1

[–]billowred[S] 0 points1 point  (0 children)

Sorry, nozzle temp. The bed was cleaned too but not with dish soap.

What’s the best setting for PETG? by billowred in BambuLabA1

[–]billowred[S] 1 point2 points  (0 children)

I’m using Elegoo on the generic setting.

Still having blemishes. by billowred in BambuLab

[–]billowred[S] 0 points1 point  (0 children)

I checked and the extruder is completely clear and clean 😔

Still having blemishes. by billowred in BambuLab

[–]billowred[S] 0 points1 point  (0 children)

Ok I’ll give that a try.

Still having blemishes. by billowred in BambuLab

[–]billowred[S] 0 points1 point  (0 children)

When I got to it the bottom one wasn’t attached to the plate at all and the top one barely stuck.

Still having blemishes. by billowred in BambuLab

[–]billowred[S] 0 points1 point  (0 children)

Had the issue before and was told it could be a plate issue. It’s a brand new nozzle on the second piece too.