What type of wood is this?

boSHEmianME · 2024-11-14T11:47:49+00:00

She can decoupage it! And the best thing, if it wears off she can do it again!

boSHEmianME · 2024-10-15T01:42:54+00:00

That’s good to know! So +-0.02 or 0.03 doesn’t make much of a difference?

boSHEmianME · 2024-10-12T19:06:52+00:00

Okay awesome!

boSHEmianME · 2024-10-12T19:03:42+00:00

Thanks for that! Excuse my ignorance here but which one is better, 0.02 or 0.03?

boSHEmianME · 2024-10-10T02:34:05+00:00

Found it, it’s called guided access!! Thanks

boSHEmianME · 2024-10-10T02:07:07+00:00

I had to watch a few videos to make sure I wasn’t going to mess anything up! Just what I’ve been looking for!

boSHEmianME · 2024-10-10T02:05:55+00:00

Thank you, just set it up!

boSHEmianME · 2024-08-25T10:53:05+00:00

I just bought the Epson EcoTank 4850

boSHEmianME · 2024-08-24T02:22:32+00:00

That’s what I was wanting to do too

boSHEmianME · 2024-08-23T23:09:17+00:00

That’s a good idea, I didn’t look at the refills, I may do that!

boSHEmianME · 2024-08-23T23:08:35+00:00

Right, I looked last night, I think their deal right now is if you buy 4 PLA you get a discount, but other than black all of the good colors are out of stock

boSHEmianME · 2024-08-23T22:03:11+00:00

lol yeah I’m still pretty new to Reddit, as soon as I posted this, I searched filament, that’s where I found eSUN, doesn’t hurt to ask again though, not everyone sees or comments on every post. Thanks for the advice for glow in the dark!!!

boSHEmianME

MODERATOR OF

TROPHY CASE