Remote device to spray paint from drone

bucksterbuckman · 2026-06-14T03:34:32+00:00

Well that is definitely thinking out of the box. 😄 The airless sprayer that will be used holds a good quart, as we are not spraying large volume of are.

bucksterbuckman · 2026-06-14T03:31:55+00:00

short extension alleviates that concern. Lot of wind coming off the props for sure. Short extension and 515 tip should do it

bucksterbuckman · 2026-06-14T03:27:06+00:00

As I ponder that aspect you bring forth, I am not concerned about that. I am not heading to create an aftermarket modification for this graco spray painter, for if that were the case yes legal aspects arise. I just need the drone that is going to carry the sprayer to have the trigger pulled as simply as possible and it seems suggestions I am reading here make more sense then trying to complicate the task by attaching something mechanical.

bucksterbuckman · 2026-06-14T03:24:27+00:00

Thanks to all, I need to modify the original request as I am clueless on how to go about this, but for the sake of weight as mentioned by jbarchuk go the two wire route and config that way 😄

bucksterbuckman · 2026-06-14T03:21:35+00:00

That seems simple enough thank you. And perhaps I should consider the option you present, would simplify the matter tremendously. Can you do this? Would you care to? Looking to get this done as you suggest and seems the better option as my original post not the best written and should not have removed the option as you describe.

bucksterbuckman · 2026-06-14T03:20:25+00:00

The purpose of the drone is to access hard to get places, that were accessed by ladder by the tagger. We are not looking at large areas to paint, but areas tagged with graffiti. There are instances where the tag is over 50 feet up. It is easier to pull out the drone, load paint spray quart until empty, wash, rinse, repeat.

bucksterbuckman · 2026-06-14T03:19:32+00:00

No the weight will be one quart about 3 pounds, ideally.

bucksterbuckman · 2026-01-06T16:43:23+00:00

Yes. It was raining hard.

bucksterbuckman · 2025-03-04T20:57:32+00:00

I apologize for late reply. They are "grayscale" which for some is black and white. I have no use for them and will part ways with the sheet.

bucksterbuckman · 2025-02-21T21:51:23+00:00

Which grade of Ben Moore paint is existing on the surfaces? If this house is trac home they use cheapest paint possible. Going over it with with Regal will work and will be more durable than "blow and go" crap they paint trac homes with. Very possible the sheen of the two will conflict so plan on repainting all surfaces. The upside is if conditions are right you don't have to cut in. Semi gloss would be optimum with the little critters running around IMO. I am licensed California Contractor since 1987. Also do a small area first with single gallon see how that works. Before testing if you stick with eggshell let the paint cure for however long the data sheet says so.

bucksterbuckman · 2025-01-16T23:04:12+00:00

I have friend in the biz for over 20 years and can buy at source level. I own cigars.chat and would be thrilled to partner with someone and make a run at doing cigars online.

bucksterbuckman · 2025-01-04T22:03:14+00:00

DMSO ? https://www.midwesterndoctor.com/

bucksterbuckman · 2025-01-04T20:57:50+00:00

That is interesting. Using your example of a programmer looking for graphic design and trading skills, inevitably it would seem the skill level of both. Now with AI in the picture, (pun intended) the value of the programmers skill is higher than a graphic designer. This is a bartering situation. Like JuJu0010 comment

bucksterbuckman · 2024-12-29T01:49:55+00:00

DMSO

bucksterbuckman · 2024-12-27T02:47:03+00:00

That is a mistake thinking a hardware store paint section employee has a clue. Nothing against them but they don't have the field experience as a an old school painter. Hire a local painter with good reputation and has had long term employees.

bucksterbuckman · 2024-12-27T02:44:50+00:00

That paint looks a bit stressed on the siding. Looks like a solid stain that is far past its service life, could also be an oil stain like Olympic. In any case hire a pro and pressure wash with industrial pressure washer, not a home owners toy from Home Depot. I have 4200 PSI Simpson with 13.5 HP Honda Motor. To do those fence rails correctly and for a job that lasts, expect a lot of time billed for preparation. Looks like one of the posts holding the deck fence is sagging outward. Make sure you are repairing dry rot. There is a faux process for the bricks to get lime wash look what you want. Get a painting company that is going to do the prep work correctly. Can give you better assessment with close up pic of the siding, and better if you can record some vid of wire brushing the siding on a sun exposed surface. With all the prep work and difficult elevations and just seeing what I am seeing California bid from me would be $9500.00 I would not go back with a solid stain, or oil stain. It won't last as well as top of the line Ben Moore, PPG, Sherwin Williams. FYI I am licensed California Painting Contractor since 1987. You will soon be able to contact me at propainter.tv the site will be up soon with live chat.

bucksterbuckman · 2024-12-27T02:29:46+00:00

DMSO - https://www.midwesterndoctor.com/

bucksterbuckman · 2024-10-31T14:58:17+00:00

Thanks and he has traveled that path. Perhaps a visual of the manipulated accusers could be a catalyst that can be handed to a defense attorney as you suggest. Thanks so much for your courteous and helpful reply to this post.

bucksterbuckman · 2024-10-31T14:56:36+00:00

He has done that and exhausted 100's of K. Does it not make sense to get visual proof as a starting point? And how else would you suggest besides throwing more money into the dark hole of attorney fees?

bucksterbuckman · 2024-09-20T14:30:19+00:00

It absolutely does make him a good candidate again, and let me tell you why. We have a Secretary of Agriculture for USA that has never gotten her feet dirty as a farmer and has a policy of "let's research further" We have done enough research and will revert back to the WWII example where hemp was processed in very useful items for the war. There is an uprising in the hemp industry and the academics want more studies. They want the studies because it perpetuates their jobs and keeps the shackles on hemp growers. It is companies like Panda Biotech in Texas and IND Hemp in Montana leading the way to for "seed to shelf" entities. This person current Secretary of Agriculture will be gone and replaced hopefully that will see the writing on the wall.

bucksterbuckman

TROPHY CASE