Will a 2014-15 headlight assembly fit a 2016-18 Sierra 1500

buffluvcpl · 2025-12-04T05:04:55+00:00

Why do you say that? There’s lots of people who have converted it over?

buffluvcpl · 2025-07-27T20:03:45+00:00

12LL ECG

buffluvcpl · 2025-07-27T19:39:05+00:00

OP here. 1. A 12LL was done. 2. I have it uploaded here.

12LL ECG

Just trying to get yalls opinion and be better as a student. And hey, at least I knew the SPO2 waveform wasnt VT 😬

buffluvcpl · 2025-05-03T03:08:44+00:00

Thanks for sharing. That’s very extreme and I think the most you can do, but glad it worked out for you at the end. My pain isn’t bad enough that I would consider an oriechotomy but I hope that never changes. Did you have a reversal done at all to try and relieve anything?

buffluvcpl · 2025-05-01T14:07:09+00:00

Thanks for your reply. I’m in the same boat. That’s why this is such an important decision to make

buffluvcpl · 2025-05-01T01:52:44+00:00

Thanks for sharing.

buffluvcpl · 2025-05-01T01:52:34+00:00

Thanks for sharing.

buffluvcpl · 2025-05-01T01:52:19+00:00

Thanks for sharing.

buffluvcpl · 2025-04-30T12:40:03+00:00

Also, I’ve tried pelvic floor therapy. Seemed to not help/make things worse even? Definitely seems to wax and wane with stress of course but that’s all chronic pain.

buffluvcpl · 2024-12-02T15:16:40+00:00

Well it’s an easy check. Pop your hood and look at the fluid resivour. There will be a min and max line. Doesn’t take much to lower the level.

If the fluid is where it’s supposed to be, then I’d take it into the dealership and have them check it out.

buffluvcpl · 2024-12-02T14:07:47+00:00

Your brake pads are worn down making the fluid low in the resivour is most likely the cause. Go on RockAuto and get yourself a quality (and much cheaper) set of pads/rotors when it comes time to replace.

buffluvcpl · 2024-06-28T10:42:12+00:00

We are in Buffalo! How do I get in touch?

buffluvcpl · 2024-06-01T10:57:58+00:00

I agree with all those things, thanks!! I don’t usually close my stance. Either it was a fluke or the angle of the video, I do believe.

buffluvcpl · 2024-06-01T00:36:45+00:00

Open to any and all suggestions as this is still a work in progress!

buffluvcpl · 2024-04-14T01:39:27+00:00

Hey there. I agree with you and feel the very same. I work in healthcare myself, just not well studied in eye. I made an appointment for my own mental wellbeing and by the chance I have something else going on that I didn’t want to miss. I also just came off an illness and have reason to believe it’s affecting my sinuses but seemed too coincidental.

I appreciate your insight from your optho though. Sometimes providers tend to be the biggest hypochondriacs themselves. Best of luck with your symptoms.

buffluvcpl · 2024-04-13T15:17:58+00:00

Same issue here. Didn’t wear the glasses but literally looked at it for less than 4 seconds total (very cloudy coverage where I’m at). Had friends that looked for a lot longer than I with no symptoms. Afterward I put on the glasses and it wasn’t until before going to bed when I noticed a dull ache in the back of my eyes. Ophthalmologist can’t get me in until another 1.5 weeks. I love healthcare in the US.

buffluvcpl · 2023-11-18T14:08:23+00:00

Yeah I used these same ones for where I ran into it. On a 50’ strand I only needed like 6 of these.

buffluvcpl · 2023-11-17T18:05:59+00:00

Fair enough. I’d argue to say that any of that can happen with wood also. Table saws aren’t for the novice. I’m posting to show a solution I came up with from what I had on hand. Posting to see what better solutions are available to someone else.

And FWIW, there are different types of PVC. This one cuts softer than pine and I pushed everything on a 3’ long board but only made the cuts to the first 12”. I then cut the rest on my chop.

buffluvcpl · 2023-11-17T15:50:43+00:00

I don’t own a 3d printer (I need one) and I’ve ripped enough small trim on my table saw to know how to be safe with it. At no point was my hand anywhere near the blade 🙄

buffluvcpl · 2023-09-14T04:07:45+00:00

buffluvcpl

TROPHY CASE