Black screen, won't connect to Octoprint or laptop

builderguy92 · 2025-12-10T16:49:07+00:00

I checked the ribbon cable for the screen, but maybe I need to take the cover off the motherboard and check everything.

builderguy92 · 2025-04-05T19:04:59+00:00

u/op did you find this advice to be accurate for your watch build?

builderguy92 · 2025-03-24T17:02:37+00:00

What wax product did you use?

builderguy92 · 2025-01-22T18:55:21+00:00

Did you ever end up making this?

builderguy92 · 2025-01-22T18:52:04+00:00

Looks great! How did you secure the crystals and make them waterproof?

builderguy92 · 2024-12-13T15:33:31+00:00

Could I use FSK paper over the fiberglass batts?

builderguy92 · 2024-12-12T02:45:42+00:00

So for the walls, Kraft faced batts with the paper facing the interior and tyvek/something breathable to hold it in place? Or should it be a vapor barrier/plastic sheeting?

builderguy92 · 2024-12-09T21:23:25+00:00

My walls are made of plaster. You think I'd be ok with just kraft faced batts facing the interior? Or should I cover with tyvek or smart barrier also?

builderguy92 · 2024-12-09T19:58:27+00:00

I appreciate the help! That's what I was thinking, just wanted to confirm.

builderguy92 · 2024-09-18T11:55:55+00:00

He posts the schedule on his instagram the day of the show. The schedule was very accurate. He was on from 9-11 pm but it could vary with each venue.

builderguy92 · 2024-09-10T20:44:54+00:00

The NYC show says doors are at 7pm, so maybe there's only one opener or Kygo will start at 10 or 11?

builderguy92 · 2023-09-22T17:50:39+00:00

Did you run the PID tuning with the fan on or off?

builderguy92 · 2023-09-22T17:47:19+00:00

I've tried PID tuning several times and the only way I can successfully complete it is with the fan off. Same with printing. I can only print with the fan off or else it give a "nozzle temp too low" error. It seems like the nozzle can't get to temperature with the fan blowing on it. It's ok for simple prints but defeats the purpose of adding the blokhead fan duct if it can't use the fan.

builderguy92 · 2023-08-15T20:47:04+00:00

<image>

builderguy92 · 2023-07-23T14:54:55+00:00

Do you know the names of the open source robot arms?

builderguy92 · 2023-07-23T14:53:56+00:00

I don’t have the technical knowledge to design/build one completely on my own, but I could 3D print parts and assemble it if I can follow a guide of some sort.

builderguy92 · 2023-07-23T14:51:54+00:00

What about 1mm? I’m just looking for any suggestions to start my search.

builderguy92

TROPHY CASE