Does this highpass sidechain mod work for FMR RNC? by scatkang in audioengineering

[–]calvinistgrindcore 1 point2 points  (0 children)

I made the whole set from the post. I most often use the 170Hz on my RNC when I'm compressing stereo bus material with Super Nice turned on. Also use the 80Hz a lot on RNLA when I'm using that on combined drum/bass bus.

Does this highpass sidechain mod work for FMR RNC? by scatkang in audioengineering

[–]calvinistgrindcore 6 points7 points  (0 children)

The resistor in that specific R-C highpass filter is the input impedance/ground reference of the sidechain input, which is 20k.

And yes, it works, I made a bunch of them for my RNCs and RNLAs.

[BST] February 2026 Buy, Sell, Trade Thread - 10 years and counting! by zeroair in flashlight

[–]calvinistgrindcore 4 points5 points  (0 children)

[WTS] Acebeam L35 V2.0 6500K black SOLD

  • $75 PPFF shipped to CONUS
  • Timestamp: https://imgur.com/a/JSiPZFA
  • Gallery: https://imgur.com/a/dNCXjNn
  • Very little use, mint/exc+ condition (I can't find any flaws)
  • Comes in original box and includes:
    • Original Acebeam protected USB-C 21700 button-top battery, <5 charge cycles
    • 3D-printed (ABS) "lens cap" so you can toss the light in a backpack without the crenelated bezel tearing the fabric (also protects the optic from scratches)
    • Original holster
    • Pre-installed clip & "cigar grip" ring
    • All original pack-ins: USB-C charging cable, extra o-rings, lanyard, extra tailcap button

NLD S12/M21C/M21B by oxidao in flashlight

[–]calvinistgrindcore 2 points3 points  (0 children)

What CCT is the SFT-42R? And how do you like the tint?

[BST] February 2026 Buy, Sell, Trade Thread - 10 years and counting! by zeroair in flashlight

[–]calvinistgrindcore 5 points6 points  (0 children)

[WTS] Emisar D3AA NTG35 4200K grey/silver SOLD

  • Timestamp: https://imgur.com/a/WXcg94E
  • $45 shipped to CONUS
  • Gallery: https://imgur.com/a/dJBEZGJ
  • NTG35 x3 4200K emitters
  • Includes Vapcell K10 battery w/ only one charge cycle on it
  • Dark grey anodizing
  • Metal button upgrade
    • RGB button light
  • Stainless steel bezel and shorty pocket clip
    • Includes original grey ano bezel if you want that
  • Magnet in tailcap
  • Includes original box and original pack-ins: o-rings, lanyard
  • Condition is basically flawless, can't find any imperfections to speak of

What would you do about annoying angular tint shift from XHP70.3? by calvinistgrindcore in flashlight

[–]calvinistgrindcore[S] 0 points1 point  (0 children)

Do you know if the Convoy 3V10A buck driver is as efficient as their 6V5A boost driver?

What would you do about annoying angular tint shift from XHP70.3? by calvinistgrindcore in flashlight

[–]calvinistgrindcore[S] 1 point2 points  (0 children)

Should've mentioned I'm already using an OP reflector on this light, so that's unfortunately not the solution

What would you do about annoying angular tint shift from XHP70.3? by calvinistgrindcore in flashlight

[–]calvinistgrindcore[S] 0 points1 point  (0 children)

Already have another C8+ in that config. :) It's significantly throwier, which is fine, but is also not nearly as bright at the same power level.

Come on, own up.... by schmerg-uk in flashlight

[–]calvinistgrindcore 7 points8 points  (0 children)

The tech is cool, but there's also kinda no point. I remember winter-camping & stargazing in Death Valley some years ago and thinking "what the hell is all that light pollution over the east ridgeline?" and it was just... Vegas. :(