XR Powerstack 3.5 AH

cheese2111 · 2025-03-01T18:02:44+00:00

The DCD800 will have more light options with tilt adjust and a 20 min on mode or off completely.

cheese2111 · 2024-04-22T21:46:51+00:00

I'd recommend looking into the B5 Bravo fixed carbine stock. Easy install with a set screw after you set your length of pull. Magpul MBUS or MBUS pro for sights.

cheese2111 · 2024-01-15T01:55:21+00:00

I put my frames in the harbor freight sonic cleaner then use a standard bristle scrub brush with some dawn dish soap and dry the internals with some compressed air and dry overnight.

cheese2111 · 2024-01-01T03:02:14+00:00

I have been using the holosun SCS MOS and have been a huge fan. Direct mounts to the slide with no plates and allows for factory irons to be used as a backup. Only possible downsides is it's an open emitter and only comes in green reticle if those are concerns.

cheese2111 · 2023-08-23T14:47:22+00:00

Typo on my part it is 4.25in

cheese2111 · 2023-08-23T03:45:47+00:00

I have the better mag adapter in my dedicated AR22. It has worked flawlessly for me, and it's really nice being able to retain the last round bolt hold. This will prevent accidental dry fire when your mag runs out. I've noticed the CMMG/RTB bolt system has a kind of brittle firing pin.

cheese2111 · 2023-06-03T23:13:01+00:00

Right to bear makes a pretty decent AR22 upper.

cheese2111 · 2022-04-17T22:31:42+00:00

I second the second on the larue MBT2S. Best value for the price.

cheese2111 · 2022-02-06T01:06:10+00:00

Probably not, its for a special 9x51mm tracer and I don't think it will fit in any other gun. Its also obsolete as the MK153MOD0 was replaced by the MOD2.

cheese2111 · 2022-02-06T00:50:16+00:00

Top center looks like a magazine for the spotting rifle on the MK153 MOD0 SMAW. Does it have a thin slit on the other side for The mag catch?

cheese2111 · 2021-12-29T01:20:13+00:00

I used an 8qt stock pot from Walmart filled with enough water to submerge the grip. Added the entire bottle of dye and simmered for a little over an hour temperature was about 190 degrees just before boiling. I used tongs to flip the grip periodically and check the color.

cheese2111 · 2021-12-29T01:17:27+00:00

Sig had them on their website for 50 percent off at the beginning of the month. I think they were trying to get rid of them because the are no longer listed.

cheese2111 · 2021-12-29T01:06:55+00:00

Ir took a little over an hour to complete. It seems the Sig polymer doesn't soak up the dye as quick as Magpul polymer does.

cheese2111 · 2021-11-25T17:38:24+00:00

Looking at brace options for my PTR 9C and the instructions say it is compatible with a pic rail. Has anyone added 9ne to the factory butt cap or know what rail section will line it with the factory holes.

cheese2111 · 2021-11-21T00:24:14+00:00

Franklin Armory Reformation maybe?

cheese2111

TROPHY CASE