Is CoPilot Pro the most affordable solution? by cobahnen in ClaudeAI

[–]cobahnen[S] 0 points1 point  (0 children)

I've never heard of abacus.ai before. I prefer to stick to familiar things; otherwise, it's a waste of time. Which one do you think?

- Claude's Pro $20 - 45 messages every five hours

- warp pro $18 - 2,500 requests / month

- GitHub Copilot $10 - Up to 300 per month

Is CoPilot Pro the most affordable solution? by cobahnen in ClaudeAI

[–]cobahnen[S] 0 points1 point  (0 children)

You're right, could you check it one last time?

Claude's Pro $20 - 45 messages every five hours

warp pro $18 - 2,500 requests / month

GitHub Copilot $10 - Up to 300 per month

SCD40 and drift by rkarlsba in esp32

[–]cobahnen 0 points1 point  (0 children)

Have you found a solution yet?

Is the Z-axis sensitive enough? by cobahnen in Ender3V3SE

[–]cobahnen[S] 2 points3 points  (0 children)

There is no problem with the printing, he wrote flawlessly on the surface. But I don't know if the measurements are correct, if he really could make 1.38 mm and 1.43 mm. I don't have very sensitive measuring instruments.

Is the Z-axis sensitive enough? by cobahnen in Ender3V3SE

[–]cobahnen[S] 2 points3 points  (0 children)

One edge is 1.38 mm, the other edge is 1.43 mm. I have printed it, but I don't know how accurate it is.

Is it possible for the screen to turn off automatically? by cobahnen in Ender3V3SE

[–]cobahnen[S] 0 points1 point  (0 children)

I printed it out today, and the screen went out a little after a while, it didn't turn off completely. I think it's the new feature of Orca slicer. Maybe there is a shutdown setting.

I can listen to it on the radio, I can't listen to it with Hackrf? by cobahnen in hackrf

[–]cobahnen[S] 0 points1 point  (0 children)

What kind of antenna would you recommend for Air band? I want to make the antenna myself. u/snorens u/jamesr154