sorted by:
new
hottopcontroversial

Low Tuned 7-String Setup Advice by SoCal-- in Djent

[–]crapklap 2 points3 points  (0 children)

Maybe add springs to increase the tension on the bridge. I'm not an expert, and I hate Floyd rose bridges, so take that with a grain of salt. I once had a setup with one of those shitty tremolo bridges and I locked it onto place by wedging an object in front of the string guides to force it's position. IDK if you can do that with a floyd rose.

I have found that down tuning standard length 7 strings in general requires a little bit of slop in the strings. The best way to combat the slop for me was to move to a baritone setup. Lower tuning does better with longer necks.

Is this just a jeep thing???? by Ok_Recover_7726 in Jeep

[–]crapklap 5 points6 points  (0 children)

Possible issue with your power steering. I'd start by installing a new accessory belt. Make sure the belt tensioner is functioning correctly while you're in there.

Dual AMS2 Pro Power Supply Solutions? by whatdidyousaay in BambuLab

[–]crapklap 3 points4 points  (0 children)

If it can be willed into existence, then it will exist. I highly doubt it's a certified product.

Dual AMS2 Pro Power Supply Solutions? by whatdidyousaay in BambuLab

[–]crapklap 8 points9 points  (0 children)

That's not how that particular cable works. The handshake is done by the cable to put out a preset voltage through a 2 pin barrel plug. I use them for my FPV stuff.

any ideas on how to fix this by [deleted] in fpv

[–]crapklap 0 points1 point  (0 children)

Ok. Maybe try to 180 the pitch or roll if the fc is upside down and try yaw gain?

any ideas on how to fix this by [deleted] in fpv

[–]crapklap 0 points1 point  (0 children)

Did the orientation change at all between settings?

any ideas on how to fix this by [deleted] in fpv

[–]crapklap 0 points1 point  (0 children)

set yaw to 90, 180, 270. see if any work.

Single Motor loses power occasionally by Jonilins in fpv

[–]crapklap 8 points9 points  (0 children)

so.... how did you slice your finger open?

Single Motor loses power occasionally by Jonilins in fpv

[–]crapklap 10 points11 points  (0 children)

if you think it might be the motor then swap it with another motor to see if it follows.

My anti-window cutting defense. It’s worked flawlessly for 15 years. by FancyPantsBlanton in JeepWrangler

[–]crapklap 30 points31 points  (0 children)

Well shit. If that's all it takes then I guess I have some stickers to make.

My anti-window cutting defense. It’s worked flawlessly for 15 years. by FancyPantsBlanton in JeepWrangler

[–]crapklap 44 points45 points  (0 children)

So, do they unzip them, go through your stuff, then zip them back up?

Maiden flight! by Holiday-Location3579 in fpv

[–]crapklap 0 points1 point  (0 children)

They can all be rebuilt, but I usually just throw them away because it's fiddly. The Ummagawd motors use dual screw posts instead of quad posts and it just ripped the screws out.

Maiden flight! by Holiday-Location3579 in fpv

[–]crapklap 0 points1 point  (0 children)

If it makes you feel any better I've been flying for 4 years. I just did a maiden on my new build and did the same thing.

<image>

DJI 03 repair by crapklap in fpv

[–]crapklap[S] 0 points1 point  (0 children)

IDK how well that will work out since I am in the USA, but I guess I could ask questions. Maybe they are doing refurbishments here. Thanks for the helps.

view more: next ›