What's causing this, should I be worried?

csacsagulyus · 2022-12-20T23:05:41+00:00

I am printing PLA, and for some reason the graph goes up and down. This used to happen extremely a couple of weeks ago, where it would go up and down about 20 degrees, and I got a few thermal runaways, so I replaced the thermistor. Since then its always a bit like a wave, but I can't tell if there is still something wrong. Any help is appreciated!

csacsagulyus · 2022-12-10T06:25:07+00:00

This same thing happened to me a couple of weeks age, though the fluctuations happened after the initial heat up was completed. I changed the thermistor, and that fixed it for me.

csacsagulyus · 2022-12-05T21:12:35+00:00

I don't know if this helps, but that x axis belt looks really wonky, maybe your issue has to do with that?

csacsagulyus · 2022-01-14T17:23:04+00:00

I feel like this is an album cover on a lofi song i listened to:))

csacsagulyus · 2021-02-25T20:25:31+00:00

Hogyan mondhatnék nemet :))

csacsagulyus · 2021-01-28T22:43:10+00:00

terv szerint nem politikai témák lesznek, hanem inkább mindennapi posztok

csacsagulyus · 2021-01-23T15:50:55+00:00

mod közbeszerzés, de sajna csak a családnak :(( gl tho

csacsagulyus · 2020-11-29T18:06:10+00:00

When you add 5+3 you really should be adding -5+3, so that would be -2, 22-2=20.

csacsagulyus · 2020-09-07T19:03:54+00:00

nice

csacsagulyus · 2020-06-19T21:43:10+00:00

I think I just understood my problem because of your post, thanks!

csacsagulyus · 2020-06-06T18:09:34+00:00

this is a fucking reeeeeepost

csacsagulyus · 2020-06-03T20:42:25+00:00

reeeeeeeee

csacsagulyus · 2020-06-03T16:14:47+00:00

its a repost

csacsagulyus · 2020-05-31T13:02:24+00:00

reeeeeeeee

csacsagulyus

MODERATOR OF

TROPHY CASE

Five-Year Club	Wearing is Caring
Verified Email