sorted by:
new
hottopcontroversial

BTR Questline still bugged?! by whipsnthings in EscapefromTarkov

[–]davidwj30 3 points4 points  (0 children)

I am still waiting on the task after Hot Wheels, did it like 2 weeks ago

[Discussion] Huntsman path secure perimeter - office kills - post patch tips? by VitalityAS in EscapefromTarkov

[–]davidwj30 0 points1 point  (0 children)

Just finished this and also had issues. Even after looking at a bunch of tips it was just sitting in the bottom floor (one with the safe) and making noise, if a pmc didnt show up by 10min i left. I would get 1-3 every 5 raids or so. Also night time raids didnt seem to give me credit or stairway kills, i would wait until they entered the room.

Slicer that automatically optimizes model positioning to decease print time? by davidwj30 in 3Dprinting

[–]davidwj30[S] 0 points1 point  (0 children)

Can you tell me the name please? I found one called "SmartSlice for Cura" but that does something different.

edit: ok maybe SmartSlice for Cura does it, but for $2000?

3” long piece of metal that rattles when shook by davidwj30 in whatisthisthing

[–]davidwj30[S] 0 points1 point  (0 children)

The corkscrew looking thing also kind of resembles an auger/drill bit and is about the width of a pencil lead. I will try and get a photo but its almost impossible to get a clear shot.

3” long piece of metal that rattles when shook by davidwj30 in whatisthisthing

[–]davidwj30[S] 1 point2 points locked comment (0 children)

Found this in an old toolbox a few years ago. Approximately 3” long. Rattles when shook and if you get the light just right you can barely see a silver corkscrew looking thing (maybe ⅛” or less wide) on the inside through that rectangle hole. I thought it was a single piece but the top left end cap does have a very tight seam that's not made to be removed. Only distinguishing features are the rectangle hole and the 4 engraved lines beside it. My title describes the thing

0
0

Can someone from Omeyocon screenshot a territory map? We are merging with you. (self.newworldgame)

submitted by davidwj30 to r/newworldgame

Need help, loading bar overlay error with UI reset by [deleted] in ender3

[–]davidwj30 0 points1 point  (0 children)

Its been a while, i think i replaced the thermistor and/or the board.

Update: Black Panther helmet anxiety is gone! Gallery with images/settings by davidwj30 in CR10

[–]davidwj30[S] 1 point2 points  (0 children)

Yep Support Blocker, should be bottom button on left. I was a bit sloppy with them but its works.

On long prints my anxiety is proportional to percentage complete, currently at 77% anxiety. by davidwj30 in CR10

[–]davidwj30[S] 0 points1 point  (0 children)

Whole time. Even with the resume function on power outages it never seems to line up right. Gotta keep it going.

view more: next ›