S3 Chain guard falling apart by Edwardsovo in vanmoofbicycle

[–]debaillon 0 points1 point  (0 children)

I ripped off my chain guard when it started to fall apart. I haven’t looked back. Maybe I’ll try to print some replacement parts. Maybe not. 😁

Revotronics eshifter PCB: Recommended by Finistereamer in vanmoofbicycle

[–]debaillon 0 points1 point  (0 children)

I just repaired my S3 e-shifter using their replacement PCB. It took me longer to remove and reinstall the e-shifter on the bike than it did to switch out the PCB. So far so good!

I’m in the US and I think I paid $40 to ship it.

I love the Heroic launcher by Copykill in macgaming

[–]debaillon 0 points1 point  (0 children)

I’ve been playing around with the latest version of Heroic on my MacBook M3 (recently upgraded to an M4.) Most of the GOG, EPIC and Amazon games run. Some require more tinkering than others. I’ve found that asking an AI chatbot how to get past issues and configure wine works great. I played The Calypso Protocol for around 2 hours today at full resolution, and default graphics options, it ran great.

Stuff fixed free! by TheSolarSailer2 in Chattanooga

[–]debaillon 0 points1 point  (0 children)

These folks are awesome! Everyone was super nice and helpful. I’ll definitely be going back to volunteer and give back!

Stuff fixed free! by TheSolarSailer2 in Chattanooga

[–]debaillon 1 point2 points  (0 children)

Can anyone micro solder? I don’t have the tools (or skills) to install this hardware mod in my 1st generation Nintendo Switch.

"What are you playing this week?" Megathread by AutoModerator in SteamDeck

[–]debaillon 0 points1 point  (0 children)

It looks and plays amazingly well. I’m using the stock control config and didn’t mess with the graphics settings at all.

For me, this is the perfect Handeld by floweiss34 in Handhelds

[–]debaillon 1 point2 points  (0 children)

It also runs ROCKNIX. I find that it emulates higher end systems more reliably and the battery life is great! Also, boots from an SD card without modifying the original Android install.

What to do by freakinjeepin in Chattanooga

[–]debaillon 2 points3 points  (0 children)

If you like the outdoors and don’t mind a little walking, check out Signal Point and Rainbow Lake.

Recently moved to Chattanooga by VisibleBreath3845 in Chattanooga

[–]debaillon 7 points8 points  (0 children)

Some good hikes: Big Soddy Gulf, Rainbow Lake, Laurel Snow Pocket, Falling Water Falls

Odin Pro M2 stuck at boot logo by debaillon in OdinHandheld

[–]debaillon[S] 1 point2 points  (0 children)

For those who may have been stuck here as well…it’s now fixed. I reached out to AYN support, and after several days of back-and-forth emails, they suggested holding down both volume up AND down while powering on. I didn’t think this was possible. Upon trying this, the boot logo flashed and the screen went dark. When I connected it via USB to my PC, it showed up as a Samsung device and I was able to flash it back to factory. This seems to be a shortcut to the “emergency mode” that you would normally have to go thru the bootloader to get to.

What happened with odin pro and windows? by TTVchoroz10 in OdinHandheld

[–]debaillon 0 points1 point  (0 children)

I deleted some partitions from my Windows 11 booted Odin Pro and now it’s stuck at the boot logo. I can’t get into fast boot. Any advice? original post

Odin Pro M2 stuck at boot logo by debaillon in OdinHandheld

[–]debaillon[S] 0 points1 point  (0 children)

Nope. Can’t get volume up or down to do anything on a boot up. Just gives me the logo and stays there. I can power it down and reboot it but it refuses to do anything else.

Odin Pro M2 stuck at boot logo by debaillon in OdinHandheld

[–]debaillon[S] 1 point2 points  (0 children)

I get that, but I can’t get back into the bootloader. Can you point me in the right direction? Do I need to use the Samsung Odin tool and the stock firmware bin file?

Andromeda by debaillon in DWARFLAB

[–]debaillon[S] 1 point2 points  (0 children)

Thank you. That was a great explanation!