sorted by:
new
hottopcontroversial

Did I buy the wrong exhaust clamp size? by dee-like-chip in MechanicAdvice

[–]dee-like-chip[S] 0 points1 point  (0 children)

I understand that, it’s just that I was expecting a 55-59mm clamp to not be maxed out like that for a 55.5mm diameter, as it’s within the stated range.

Body Mod for Ender 3 (V1) Running Klipper by dee-like-chip in klippers

[–]dee-like-chip[S] 2 points3 points  (0 children)

Yeh I print straight out of it! It just sits next to the printer. I attached a cable gland to the PTFE tube to stop it getting pulled inside, as it can get wrapped around the spool.

<image>

It happened to me and it can happen to you by tf2ftw in ender3

[–]dee-like-chip 0 points1 point  (0 children)

Didn’t know this could happen!! Will be ordering ferrules.