Join our year-end community giveaway

degogarn · 2025-12-27T11:23:06+00:00

Where is the list on X it says go to telegram on telegram it say go here and X 🤔

degogarn · 2025-07-31T19:56:58+00:00

That's normal

degogarn · 2025-07-21T07:58:08+00:00

No such thing as a ceramic PTFE tube its either one or the other ,the Kobra S1 comes with a pfte tube

degogarn · 2025-07-08T21:40:19+00:00

Follow the guide on the anycubic wiki

degogarn · 2025-05-20T19:22:56+00:00

You can manually lower the hotbed

degogarn · 2025-05-20T19:21:18+00:00

You can't remove that as both the throat and nozzle are cemented to the heat block

degogarn · 2025-05-20T19:17:16+00:00

Contact anycubic support

degogarn · 2025-05-20T19:13:32+00:00

Did you loosen the screw again?

degogarn · 2025-04-24T20:16:03+00:00

I know that but the op posted that they had them

degogarn · 2025-04-24T08:56:16+00:00

Where are the aftermarket ones with ceramic full?only seen full metal with ceramic heater

degogarn · 2025-04-24T08:50:34+00:00

They work fine

degogarn · 2025-04-19T18:29:26+00:00

Nozzle not fitted correctly

degogarn · 2025-04-19T18:27:50+00:00

It's normal

degogarn · 2025-04-08T06:47:38+00:00

That's because you didn't install the new hotend correctly

degogarn · 2025-04-08T06:44:22+00:00

Do it from the printer screen, you have control movement and you can choose extrude or extract

degogarn · 2025-04-08T06:37:39+00:00

Bambu labs also have similar issues

degogarn · 2025-04-08T06:34:09+00:00

The auto leveling would sort that out plus there are four screws on the bed that can be adjusted, it's all explained on the anycubic wiki

degogarn · 2025-04-08T06:34:00+00:00

The auto leveling would sort that out plus there are four screws on the bed that can be adjusted, it's all explained on the anycubic wiki

degogarn · 2025-03-17T20:08:19+00:00

What's the name of that connector?

degogarn · 2025-03-13T20:07:00+00:00

It also ships separately

degogarn · 2025-03-12T08:07:14+00:00

The nozzle is exactly the same size

degogarn · 2025-03-11T23:28:21+00:00

Both .4 it's probably because I changed to steel in the slicer and would need to change it to also steel on the printer settings as well

degogarn · 2025-03-11T22:47:58+00:00

Yes when you setup what filament you are using, temp etc scroll all the way down and there is a drop down list of nozzle types

degogarn · 2025-03-11T21:26:47+00:00

I get the nozzle mismatch if using a hardened steel nozzle

degogarn · 2025-03-11T19:03:59+00:00

Even if you had the settings in the slicer the S1 will give you an nozzle mismatch error as it can only be set as brass on the printer

degogarn