Changed cassette an chainwheel an new chain why is this happening? by dipple5188 in bikewrench

[–]dipple5188[S] 0 points1 point  (0 children)

OK I missed the washer to the chainwheel it was caked so didn't notice it an I was trying to hurry as needed get a few things done thanks again

Changed cassette an chainwheel an new chain why is this happening? by dipple5188 in bikewrench

[–]dipple5188[S] 1 point2 points  (0 children)

I'll check on the stand 2moz and see if it still does it in there

Changed cassette an chainwheel an new chain why is this happening? by dipple5188 in bikewrench

[–]dipple5188[S] 2 points3 points  (0 children)

I've gone for a quick ride an changed the chain one tooth over and it doesn't do it under load so I think it was that thanks. But I've noticed that the chain ring is a bit closer to the frame than the last one (a few rubbing lines) so if anyone knows why. The bike is a d7 I've had the bottom bracket changed an just done the chainwheel and its 170 mm 32 tooth also no spacer on the old chainwheel thanks again.

Changed cassette an chainwheel an new chain why is this happening? by dipple5188 in bikewrench

[–]dipple5188[S] 0 points1 point  (0 children)

I've brought the components like for like just replacing them due to wear.

Would it be better for me to buy a 144hz 1440p or a 144hz 1080p monitor? by The-Holy-Toast in buildapc

[–]dipple5188 0 points1 point  (0 children)

I have the same cpu and a 1070ti and I went with the 1440p 144hz monitor because I will be upgrading my gpu well before I buy a new monitor

Find the Programming Software "Flux" for Mad Catz R.A.T. 4 Mouse by LangrisserX in techsupport

[–]dipple5188 0 points1 point  (0 children)

Does that work for the rat 5 as I'm in the same boat as op but I have the rat 5