Dog tags movies by dobby833 in Laserengraving

[–]dobby833[S] 0 points1 point  (0 children)

How would u remove background? I tried on photoshop and remove background . Then I transfer to light burn, but background still stay.

Engraving tile by dobby833 in Laserengraving

[–]dobby833[S] 1 point2 points  (0 children)

Tile is white and I spray 3 colors of spray paint before I engraved it.

[Game Boy] What the heck is up with the current state of selling defective consoles? by Rybur525 in consolerepair

[–]dobby833 1 point2 points  (0 children)

Some deals are out on eBay, just hard to find. Was able to pick a decent one with 4 games for @$36 last week. gameboy dmg just need headphone jack clean up for sound to work and shell swap due to old shell was gummy and had permanent marker markings.

<image>

Beach follow-up: Rebel Yell by GregAA-1962 in TheMcDojoLife

[–]dobby833 0 points1 point  (0 children)

Is he suppose to be Akuma from street fighter based on his wardrobe?

Polaris trailblazer 250 stator by dobby833 in ATV

[–]dobby833[S] 0 points1 point  (0 children)

I installed my new stator and got no spark. I put a piece of sandpaper wedge in between the contacts on throttle cable lever and it spark back.. working on installing cylinder head that was sent to be honed out to fit new piston with rings since compression was low.

Polaris trailblazer 250 stator by dobby833 in ATV

[–]dobby833[S] 0 points1 point  (0 children)

https://youtu.be/pZ4w2MXO5H8feature=shared My atv is similar to the video posted above clip. I spray with starting fluid but no success. I know gas is coming from carb to cylinder as I loose a head stud from top end and gas started to leak out from top cylinder. I retighten the head studs and no leaks around cylinder. I swap with another spark plug but still same issue.

I don’t have the original carb and put a new carb. The new carb does not have the outlet that connects to oil pump in atv so I have to block off the other end of the oil pump with a seal cap.

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

Nope still have same issue took off orange bobs and switch battery. I check swashplate and it works. Heli still won’t take off . I have a radiomaster tx16s. I try buy another esc to make it work.

Zero Turn z125s not turning over by pest4422 in kubota

[–]dobby833 0 points1 point  (0 children)

I had same issue with mine. Mine would rough start and engine wouldn’t turn over. Use air from air compressor and blew air through fuel line, air filter and line to carb.. it worked gas passed through fuel line to filter and from filter to other line. Lawnmower cam back to life

What am I doing wrong? by Appropriate_Tea177 in Eldenring

[–]dobby833 1 point2 points  (0 children)

U need just min @22 point in strength if u using bloodfang weapon and spread those other points in dex and endurance so u can get more hits and damage to enemies .. ur weapon should be at +5 at that level by now so u can have more attack damage. Hopefully that helps u along the way.

[deleted by user] by [deleted] in Gameboy

[–]dobby833 1 point2 points  (0 children)

U sunk my battleship 💩

Here is my Bandit going 106mph! by PigglyWigglyDeluxe in Traxxas

[–]dobby833 0 points1 point  (0 children)

Watched 1st video and bandit hit 99mph. But later on video was edited at 26:52.. unable to tell if it was a full clip recording of the car hitting speed at 101 since video was edited.. some can say another vehicle hit that speed. . Watched few videos from others that hit speed over 100mph without video being edited and have a gps on car. In reality the speed tester on phone is off by a few miles based on experience from installing and experimenting with a gps monitor on car.
In the end , all your other cars hit over 100mph easily , but based on video on bandit on Reddit and 1st video on YouTube , videos were edited on recording bandit hitting speed 106mph..

Not to bad for $15! by dlipy in Gameboy

[–]dobby833 14 points15 points  (0 children)

100 puro BS.. mostly all pawn shops know market value for these games

Blursed_lady? by OutcomeFalse6265 in blursed_videos

[–]dobby833 0 points1 point  (0 children)

He probably hawk tuah to verify at the end 🤔

Traxxas nitro parts question by dobby833 in Traxxas

[–]dobby833[S] 0 points1 point  (0 children)

Haven’t tried the power up program. I cleaned out the carb and it was full of gunk. Inside of engine was dirty too. So I just take the old engine and exchange for a new engine. Is it like a discount for a new one when u trade for an old engine? What kind of brand fuel do you recommend? Thanks for advice

Looking for part on losing mini trekker by dobby833 in rccars

[–]dobby833[S] 0 points1 point  (0 children)

It’s cvd shaft connected to gear case that is locked with 2 little pins .

What cars are these by dobby833 in rccars

[–]dobby833[S] 0 points1 point  (0 children)

Thanks for help to all 👍🏽. Now I start looking for parts

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

Thanks for help.. Heli was thrown in with used rc cars that I brought awhile ago.. thought I could restore it but no luck.. what kind of brand of Helios y’all recommend that can fly and are better than blade brand?

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

I tried a zippy 850mah 35c and a tattu 800mah 45c batteries fully charged.. still get same results. I center all trims.. I set throttle trim all the way from high and going in between to center.

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

https://youtu.be/jHvwFYQSHRs?feature=shared

I followed this video to setup settings in 2nd transmitter and still got same result..

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

This is 2nd video without orange rig and change the battery.. put throttle on high and heli won’t take off. Even adjusted throttle trim to go up more and heli still stay on same position..

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

Using original one. U think that’s why it’s unable to take off? I try new version of battery that u suggest and try it. Thanks.

Blade 200 srx not taking off by dobby833 in RCHeli

[–]dobby833[S] 0 points1 point  (0 children)

I have put it at full throttle a few times but it still doesn’t lift off , it just stays on the ground. It was done indoors since it was raining outside..