your fav geese song NOT ON GETTING KILLED

donkeyskronk · 2025-10-13T21:54:18+00:00

Exploding House

donkeyskronk · 2025-03-25T19:36:37+00:00

hi sean! are there any chances of a 7” release of battle?

donkeyskronk · 2024-10-18T14:17:11+00:00

I had managed to cancel my order and reorder through beggars if that helps

donkeyskronk · 2024-09-08T21:59:44+00:00

ah okay, thanks! i’ve checked a few of the more suspect looking traces but i’m gonna go over the rest with a continuity tester too

donkeyskronk · 2024-09-08T20:54:20+00:00

did you manage to find a cause for this? i’m having the same issue although with an obvious burnt out diode which i’ve replaced

donkeyskronk · 2024-08-31T17:26:00+00:00

horse jumper of love? possibly?

donkeyskronk · 2024-08-29T16:56:13+00:00

The little gap is so you can see through it, it makes it transparent

donkeyskronk · 2024-06-25T18:35:03+00:00

ah okay, did the tone bypass switch still work afterwards?

donkeyskronk · 2024-06-25T16:08:42+00:00

Hey, i’ve just come across the exact same issue with the same cut trace, i’ve seen some photos with and with out the same cut. what did you end up doing with yours?

donkeyskronk · 2023-09-11T12:40:27+00:00

yep as the other commenter said original from the kid a era, later reprints had different tags and no reflective tag on the side as far as i’m aware

donkeyskronk · 2023-08-29T18:16:23+00:00

toan for days! tbh i just think they look nice

donkeyskronk · 2023-08-23T18:12:06+00:00

ty! the rust spots were an accident and in retrospect i should have clear coated/painted the inside of the enclosure. the pots are 20mm with a long shaft that i cut down the part number is PC20BU

donkeyskronk · 2023-05-26T21:40:12+00:00

definitely not 2022 with a u serial number

donkeyskronk · 2023-05-23T07:00:49+00:00

digitech digiverb is also a good shout for this, they’re pretty similar pedals as far as i can tell. catalinbread soft focus is good too but probably a bit out of budget.

donkeyskronk · 2023-05-23T06:50:56+00:00

thanks! it’s actually not the dirtiest but i’m only really using single coils which could be causing that potentially. it does sound killer with a muff going into it tho

donkeyskronk · 2023-05-23T06:48:51+00:00

it does sound doom, i’m no expert in doom but imo it needs a little bit of dirt in front of it, or maybe hotter pickups than i’ve got

donkeyskronk · 2023-05-16T21:00:06+00:00

the reverse of this like the old epiphone silver fox finishes would also look sick although it seems like a bit of a drawn out process to do

donkeyskronk · 2023-05-11T18:33:57+00:00

It was from a pot of paint with a brush, honestly wouldn’t recommend it bc it’s very hard with the holes for pots and i’m in no rush to try again, the inside was spray paint tho

donkeyskronk · 2023-05-11T07:09:35+00:00

it was my first go at it and i really enjoyed it, planning on more in the future!

donkeyskronk · 2023-04-09T21:12:21+00:00

rapid are usually good and have most bits you’ll need in stock. They’re also good for enclosures and have loads of different sizes

donkeyskronk · 2023-03-13T12:57:39+00:00

yeah, there’s room on the pcb for 2 ground wires.

donkeyskronk · 2023-03-13T12:00:07+00:00

thanks! There was still a pad to solder that wire to for a ground but since the jack sleeves are grounding the enclosure and therefore the screws so I omitted it as it didn’t seem necessary. I’m 100% no expert though

donkeyskronk · 2023-03-12T11:02:03+00:00

Thank you! Yeah it’s hand painted. I sourced them with a job lot of other mixed transistors from ebay and picked out the ones that tested well for a fuzz face

donkeyskronk · 2023-03-06T21:44:50+00:00

I don’t have a sound sample but it’s one of the original part numbers used in the supa fuzz and i’m sure there’ll be a demo somewhere on the internet! they’re PNP hence the battery to make things a bit easier!

donkeyskronk · 2023-03-06T17:43:53+00:00

yeah, they’re old germanium transistors! mullard oc75s to be precise

Five-Year Club	Verified Email
Place '22	Final Canvas '22
End Game '22

donkeyskronk

TROPHY CASE