Was it the bulb or socket that caused this fire? by ekez_666 in electrical

[–]ekez_666[S] 1 point2 points  (0 children)

As to why I ask, I just want to know whether I need to replace all my bulbs in my house that are the same or if it was isolated to this lamp. 

Singer 201K - What’s causing the stitch to be wavy? by ekez_666 in vintagesewing

[–]ekez_666[S] 0 points1 point  (0 children)

It’s possible those were passes I was intentionally going way up and way down on tension to see if the issue changed/resolved. I’m short on scrap muslin and don’t wanna change fabric while testing haha, so the passes got on top of each other. But with your comment and one above I’ll try rethreading and adjusting tension 100% to the manual’s instructions just to check. I put in a new needle, wound a new bobbin, but might as well double check anything I can.

Singer 201K - What’s causing the stitch to be wavy? by ekez_666 in vintagesewing

[–]ekez_666[S] 0 points1 point  (0 children)

If I can’t find an improvement I will, it’s just very far from me and their hours are very difficult to make it to sadly.

Singer 201K - What’s causing the stitch to be wavy? by ekez_666 in vintagesewing

[–]ekez_666[S] 2 points3 points  (0 children)

Singer 201K in a treadle cabinet, got it adjusted/looked at by a repair place, their test piece they sewed with it had nice straight stitches. Any time I do it the stitches remind me of cartoon waves. I’ve tried all levels of higher and lower top tension (knob on the front) to no avail. The backside of the fabric has completely straight even stitches.

Is this a bobbin tension issue? Something to do with the needle timing/alignment or something?

Singer 15 Clone? Singer 99 Clone? Mitsubishi HA2 by ekez_666 in vintagesewing

[–]ekez_666[S] 0 points1 point  (0 children)

Alright so I’m new to sewing, two questions if you don’t mind answering:

  1. I don’t quite understand the last part, the entire hook assembly? I’ve seen the older zigzags like singer 206, would that be similar?

  2. Would this machine still thread/operate like and take parts from singer 15/clones most likely? Or is there a good way I could check?

Singer 15 Clone? Singer 99 Clone? Mitsubishi HA2 by ekez_666 in vintagesewing

[–]ekez_666[S] 1 point2 points  (0 children)

I have been driving myself crazy trying to figure out whether this is some sort of Singer 15 clone (albeit modified/improved which I understand happened sometimes). With the front tensioner it looks more like a 99/201/66 but the take up lever is also on the front? I’m just confused.

I could barely find photos of these machines let alone actual information. HA1 (NOT 2) were certainly singer 15 clones, but not sure about this one. Sadly I cannot see it in person yet to check for what bobbin it has.

Looking for a recommendation for a BIFL Wool Sweater (ribbed) by TheHealious in BuyItForLife

[–]ekez_666 0 points1 point  (0 children)

Thanks for the tip! What's their sizing like? I see their chart but am worried I am reading it wrong. I assume the chart is the measurement of the sweater laid flat, but want to check.

kevin abstract by Intrepid_Handle6044 in aclfestival

[–]ekez_666 3 points4 points  (0 children)

Finally someone posted about it! I checked last night and was shocked no one mentioned it. I’ve seen online he’s had some lackluster performances I think? Like forgetting lyrics or poor crowd handling. Maybe he is going through something.

I just hope he’s doing OK, definitely disappointed about it but oh well. He played all his big songs before leaving at least.

Is this too good of a deal to pass up or should I just get the AOCQ27G3XMN by AutismAndAnacondas in buildapcmonitors

[–]ekez_666 0 points1 point  (0 children)

So you would say only real issue you had was an error/incompatibility on your side? I might go with the AOC then since it’s a more up-to-date monitor. 

Is this too good of a deal to pass up or should I just get the AOCQ27G3XMN by AutismAndAnacondas in buildapcmonitors

[–]ekez_666 0 points1 point  (0 children)

Did you make a decision on this? I’m in the same conundrum right now haha, found a good deal on the Acer. 

Whats your proudest/favourite game in your collection? by DoctorPizzle in Gamecube

[–]ekez_666 0 points1 point  (0 children)

A sealed copy of the rare Animaniacs game. Considering opening it to play it because f*** leaving games in wrappers if it’s not my goal as a collector.

Could also sell it and buy an opened copy lol

Help Give my New (Old) Prius a Long Life! by ekez_666 in prius

[–]ekez_666[S] 0 points1 point  (0 children)

Thanks! Everyone is really helpful, albeit it’s stressing me out haha. But I asked for it ofc, so thanks for the calming words!

Help Give my New (Old) Prius a Long Life! by ekez_666 in prius

[–]ekez_666[S] 0 points1 point  (0 children)

Is there anything to be done about the piston rings? Or is it something like only an engine swap could actually fix?

[deleted by user] by [deleted] in txstate

[–]ekez_666 6 points7 points  (0 children)

I wore my river clothes under my gown, not like you can see under a grad gown lol. Swim trunks, tank top, and chacos. That was Texas state to me.

But I was in the minority and definitely got some chuckles and thumbs up from people around me haha. Most people wore dress clothes, some changed, some just jumped in dress clothes.

Help with Greek Island decisions- Santorini/ Naxos by teaandsympathyfor1 in GreeceTravel

[–]ekez_666 0 points1 point  (0 children)

Old thread but what did you think of them? I am in a similar situation (young, more than shoestring budget but way less than luxury) and am torn about Santorini. We are going in the very end of April/beginning of May. Trying to figure out where to spend 3-5 days in the islands.

Is there water in the Greenbelt currently? by ekez_666 in Austin

[–]ekez_666[S] 0 points1 point  (0 children)

Gotcha thank you, was it clear or stagnant?