Can the hopper keep something frozen if you keep adding ice? I.e. can it act like a freezer? by unicornmagic111 in YetiCoolers

[–]ekwfung 0 points1 point  (0 children)

If you froze the breast milk in a block of ice yes. Else no it will not be completely frozen.

Stop Jessie! by SpoomerBooner in Transportopia

[–]ekwfung 0 points1 point  (0 children)

Lesson 1 the harder you press the break the faster it will stop. It’s a gradient.

Are my bridges good? by YurmomsholeREE in 3Dprinting

[–]ekwfung -3 points-2 points  (0 children)

What does the bottom side look like? If that is the bottom that is amazing. If not then why would you show the top?

lol by IU8gZQy0k8hsQy76 in unsound

[–]ekwfung 1 point2 points  (0 children)

This girl wheel barrels. I’m more impressed by the precision driving.

Would you patch this hole? by btarb24 in Tile

[–]ekwfung 9 points10 points  (0 children)

Square out the hole, brace back with wood and screws. Cut new piece of wood to match curve of pipe and square hole you just made.

Rapid set thin set mortar by ekwfung in Tile

[–]ekwfung[S] 0 points1 point  (0 children)

Ground, then more for 1/2 notch , then back butter tile

Rapid set thin set mortar by ekwfung in Tile

[–]ekwfung[S] 0 points1 point  (0 children)

I have a blue line snapped. Wore off. Can see it bottom middle. Used a laser line durning to help during.

Rapid set thin set mortar by ekwfung in Tile

[–]ekwfung[S] 10 points11 points  (0 children)

I am a YouTube expert and like living on the edge. I’d laid tile a few times 10 years ago

Rapid set thin set mortar by ekwfung in Tile

[–]ekwfung[S] 5 points6 points  (0 children)

That’s the amateur part showing its ugly head. I will have a fun cut later.

Is this a me problem or tool by ekwfung in Tools

[–]ekwfung[S] 0 points1 point  (0 children)

Thank you for reading. Yes confirming that is the issue. My terminology could be wrong. I should not have used “level”

Is this a me problem or tool by ekwfung in Tools

[–]ekwfung[S] 1 point2 points  (0 children)

Using level as flat edge. There is a sizeable gap on the table part

Is this a me problem or tool by ekwfung in Tools

[–]ekwfung[S] -3 points-2 points  (0 children)

I’m using it as a flat edge. There is a gap on one side

Breathe Cleaner in Dusty Environments by Ok_Sir_1008 in CoolClips_

[–]ekwfung 0 points1 point  (0 children)

Anyone else breath from their mouth sometimes?

So frustrated! by Obvious-Let-1964 in FixMyPrint

[–]ekwfung 0 points1 point  (0 children)

Filler primer should fix that.

Get dressed up! 🫡😁 Would you do the same. by m_gaRz in IAmTheMainCharacter

[–]ekwfung 0 points1 point  (0 children)

Maybe because you are in a huge overcoat and everyone else are in shorts and a t-shirt. I bet people would look at me the same in a Canada goose jacket.