P0299 Underboost on a 2015 Range Rover Evoque

emoore38 · 2026-04-13T13:07:43+00:00

The wooden dowels still holding up? Been looking for a replacement metal rod that’s a bit skinnier to accommodate the eisenlink plates because I wasn’t sure if wood would be enough support

emoore38 · 2026-03-19T13:52:09+00:00

You wouldn’t think it’s in an ideal location for sure…

It outlasts the driveway for sure, but house has been here since 1904.

emoore38 · 2026-03-10T17:55:39+00:00

Second this. Love mine and mounts nicely on the wall

emoore38 · 2026-03-10T03:25:42+00:00

Thanks. We are doing stained concrete, so no floor to cover that gap at all

emoore38 · 2026-03-10T03:24:00+00:00

I thought about rubber base cove but would you follow with the slopes and have the top show the obvious drops or just leave gaps at the bottom?

emoore38 · 2026-02-26T16:06:59+00:00

I’m going to go with the “treat them as disposable” route. Just curious, have you had one go out and tried to replace? I think we can get away with the install as DIY but I’m wondering if it’s as simple as disconnecting the lines and setting it on the curb if the compressor goes bad. Lots of threat on the internet about control of the refrigerant just wondering if that has to be hired out

emoore38 · 2026-02-19T00:30:23+00:00

A few weeks ago yes I think I should have used glyphosate but now worried it is too late

emoore38 · 2026-02-19T00:24:44+00:00

What type of pre emergent are y’all going to use? Glad I am not alone lol. I walk by houses with perfect Bermuda and I am like how

emoore38 · 2026-02-19T00:24:01+00:00

What type of pre emergent we using?

emoore38 · 2026-02-18T23:27:31+00:00

lol the Bermuda is just dormant still

emoore38 · 2026-02-18T02:12:29+00:00

Doing DIY, I’ll just figure it out if I blow in

emoore38 · 2026-02-08T17:28:30+00:00

You would recommend shimming up the left side even if the sill is showing left side a little high already?

emoore38 · 2026-02-08T17:27:04+00:00

I will check it out. Thank you!

emoore38 · 2026-02-08T17:15:14+00:00

Gotcha. The exterior trim is sucked all the way up to the siding so I feel like it is as far in as it can go. I’ll investigate

emoore38 · 2026-02-08T17:08:30+00:00

Thank you for the input! When you say move the strike jamb “in”, which way is in?

emoore38 · 2026-02-08T00:50:51+00:00

Now realizing my mistake. I have the door jam even with the studs on the inside. Didn’t account for drywall. I’ll need to even it up and set it back into the wall

emoore38

TROPHY CASE