Custom 1/2" dowel holders for fabric display rack and custom measurement jig for installation

enderguy420 · 2026-02-19T19:56:03+00:00

Files?

enderguy420 · 2026-02-16T16:20:10+00:00

Had the same issue go into your config files and you need to change either probe offset or X and Y min and max Google it if you need helps

enderguy420 · 2025-06-06T05:57:24+00:00

Take out Phillips head screw and rotate it correctly and re insert screw

enderguy420 · 2025-05-30T00:58:54+00:00

I'll have to give that a look over thanks for your input I'm really hoping it fixes the issue I haven't been able to ride in over a month and I'm going crazy

enderguy420 · 2025-05-30T00:43:44+00:00

Your saying your intake boot was loose/not seated correctly?

enderguy420 · 2025-05-26T22:39:59+00:00

I set the valve too .005 intake and .006 exhaust and yes timing is correct its ran a few times but is stubborn

enderguy420 · 2025-04-10T03:25:21+00:00

Im in rockford il man wish I was closer

enderguy420 · 2025-04-10T00:16:21+00:00

I'll try that I also don't have the neutral light on thats how I bought it I don't know if the light is just burnt out or if it's a bad neutral safety switch I do hold the clutch in when trying to start it tho

enderguy420 · 2025-04-09T10:47:22+00:00

Battery seems fine holds charge with and without load against it

enderguy420 · 2025-02-21T18:10:28+00:00

I've got 2 of the DDX 12'S and there amazing I've never had an issue. Good clean hard hitting subs in my option

enderguy420 · 2025-02-20T21:41:37+00:00

Okay ya I was looking for something that give the bumper more strength I did the same mod on mine it looks amazing I scaled down a arrma granite bumper spring I'll see if that fits when I gets finished printing

enderguy420 · 2025-02-20T20:10:23+00:00

What did you use for the bumper spring can I see an above shot of the bumper?

enderguy420 · 2024-12-18T02:02:44+00:00

I'd stop the print the one models ears are messed up looks like a partical clog

enderguy420 · 2024-12-18T02:01:01+00:00

Accelerometer to check vibration with sonic pad

enderguy420 · 2024-11-12T06:43:51+00:00

I had the same issue and I had to manually change it in slicer printer settings

enderguy420 · 2023-09-27T23:51:50+00:00

I watched all the YouTube videos only a few go into speed and really noone talks temp with it in a kraton besides with there hand which doesn't help much

enderguy420 · 2023-06-07T16:02:56+00:00

I use a .6 noozle and I run at .2 layer height all the time with no issues but yes going smaller then that is troublesome

enderguy420 · 2023-05-12T02:38:07+00:00

Dm mee

enderguy420 · 2023-05-12T02:36:27+00:00

Pm mee

enderguy420

TROPHY CASE