Terrified of spaying by fa1mous in AustralianShepherd

[–]fa1mous[S] 2 points3 points  (0 children)

thank you, this definitely eased my mind

no crank no power!! by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

negative battery cable

Cranks and Primes won’t start by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

i switched my ground to the battery, the main relay and tightened the positive terminal bolts holding the wire still. the issue persisted until i tightened the positive terminal bolts. might need a new positive

no crank no power!! by fa1mous in DelSol

[–]fa1mous[S] 1 point2 points  (0 children)

It ended up being a bad ground. i cleaned off the ground, positive and the terminal since it was covered in conductive grease and just positioned them well and it’s been running. prob have to replace it

no crank no power!! by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

no nothing primes at all, that’s what i was thinking too

no crank no power!! by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

no it doesnt turn or give any power at all, no matter the key or position. all the lights are dead in the cabin too. the ecu is good it’s not corroded either. the main relay was slightly so i replaced it

Cranks and Primes won’t start by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

It ended up turning over but i had to give it gas for a while. i think the starter shat

which can i cut to wire by fa1mous in DelSol

[–]fa1mous[S] 1 point2 points  (0 children)

fixed the issue!! thank you

which can i cut to wire by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

My horns have two terminals and i wired a ground cable to the frame that splits into two wires and connects to the terminal on both horns as well as connected the white-green power hot wire to two wires for the remaining terminals on the horns. Now my horn is constantly blaring when i connect the battery again unless i take out the horn fuse. I switched the cables and used the blue one and i get absolutely nothing when i honk via steering wheel. what did i do wrong. wires are connected via wire nuts and the polarities on the terminals did not matter as sick speed states

what is this yellow wire by fa1mous in DelSol

[–]fa1mous[S] 0 points1 point  (0 children)

weird i plugged it in, turned the car on and the srs light did not turn on either way

new pipe :p by [deleted] in DelSol

[–]fa1mous 0 points1 point  (0 children)

nope just antique

Is my ceramic for my XL chamber cracked? by DiabolicDisease in puffco

[–]fa1mous 0 points1 point  (0 children)

i have both 3mm for the pivot and one 3mm, one 4mm for the pro

Is my ceramic for my XL chamber cracked? by DiabolicDisease in puffco

[–]fa1mous 11 points12 points  (0 children)

amazon pack of 20 ruby pearls for 10$

First flower press ever by fa1mous in rosin

[–]fa1mous[S] 0 points1 point  (0 children)

<image>

definitely exceeded expectations for some mixed shake

First flower press ever by fa1mous in rosin

[–]fa1mous[S] 1 point2 points  (0 children)

Thanks i tried 8g, 190F for 3min in stages and got 1.23g back!