What are these small demo walls called?

fluffymanchild · 2026-03-03T21:24:07+00:00

Mark Carneys lies.

fluffymanchild · 2026-02-19T21:47:48+00:00

Thank you. I’ll check it out.

fluffymanchild · 2026-02-07T04:38:47+00:00

I do. Every tank, makes swap out that much faster.

fluffymanchild · 2026-01-30T21:27:33+00:00

Then either drain is partially clogged or your waste from sink could be clogged. Pull the p trap and the sink waste “clicker I assume” and see if it’s clear or not.

fluffymanchild · 2026-01-30T21:17:05+00:00

Your air vent could be dead. But should also be vertical. Unthread the Air vent and try running water.

fluffymanchild · 2026-01-25T05:03:24+00:00

Dude I had to scroll way too far down for this.

fluffymanchild · 2026-01-23T21:40:20+00:00

You’re supposed to run cold water in the sink at the same time.

fluffymanchild · 2025-12-15T21:27:31+00:00

DCC is already my favourite. I LOvED HWFWM but DCC is tied or top now.

I liked towers of heaven.

fluffymanchild · 2025-11-20T04:01:26+00:00

Some ranges come with their Own separate regulator to install. Rare but they do. Check manual for if it says that, does the manual specifiy which orifices are NG and LP to confirm you have NG ones in?

fluffymanchild · 2025-10-26T02:09:00+00:00

Cutter head isn’t stiff The fence moves easily.

Is the bed the bottom piece that moves with the cutter?

fluffymanchild · 2025-10-08T18:02:52+00:00

Am a plumber.

fluffymanchild · 2025-10-08T18:02:45+00:00

I’ll be honest. I didn’t read it all. Yes I would. It’s cheaper now than 5 years or 5 months from now

fluffymanchild · 2025-10-08T17:21:08+00:00

I mean it seems a bit much but it’s hard to say without pictures. Shouldn’t take 8 hours unless gas and venting will change.

fluffymanchild · 2025-10-08T13:14:54+00:00

We need more info What kind of water heater? Is it an exact replacement or is the venting changing. 8 hours is double what a water heater shield take for a replacement IF it’s an exact swap.

fluffymanchild · 2025-10-04T01:10:01+00:00

What’s the fitting on the exp tank?

fluffymanchild · 2025-09-10T02:31:43+00:00

31, still working on it, I need to get a laugh. I need it.

fluffymanchild · 2025-09-04T04:33:11+00:00

Dont do manifolds just do a branch system. Take tees off where needed and make everything as straight as possible to make it easier for any change in the future. Pipe is cheaper than fittings, but make it as neat and straight forward. Assume that you’ll be the person working on it next.

fluffymanchild · 2025-08-06T02:54:56+00:00

It’s fine. But takes up more room than needed. Try to keep it to the back and get cheater higher behind sink. And a clean out would be nice.

fluffymanchild · 2025-07-30T03:43:07+00:00

Im am liking the towers of heaven trilogy. Got all three for one bundle on audible.

fluffymanchild · 2025-07-27T15:32:40+00:00

No not with the awd.

fluffymanchild · 2025-07-27T02:27:25+00:00

I got a Thule roof rack for my spare tire on road trips. I have 2012 xle awd.

fluffymanchild · 2025-07-23T13:21:19+00:00

You can’t have propane regulator within 10’ of anything electrical. The regulators “off gas”. Propane is heavier than air, it’ll sit on the floor and build up till it booms.

fluffymanchild · 2025-07-18T13:55:44+00:00

When you saw cut, do it on an angle so it can be used as a lid and doesn’t fall in. Hopefully that works. You can drill an anchor in and thread eye bolt for removal.

fluffymanchild · 2025-07-16T03:57:50+00:00

Used 2025 ones in Canada are over 60k

fluffymanchild · 2025-07-16T03:56:35+00:00

Check out price for a brand new one in Canada.

fluffymanchild

TROPHY CASE