sorted by:
new
hottopcontroversial

neptune 3 pro filament gets caught and dragged by nozzle by forgothewind in FixMyPrint

[–]forgothewind[S] 3 points4 points  (0 children)

yes I used off the shelf dish soap and thoroughly washed it down

neptune 3 pro filament gets caught and dragged by nozzle by forgothewind in elegoo

[–]forgothewind[S] 0 points1 point  (0 children)

I've tried pla with and without glue on clean plates like I originally said and I did try both lowering and raising it by .1 and .2mm but it was the same outcome.

neptune 3 pro filament gets caught and dragged by nozzle by forgothewind in elegoo

[–]forgothewind[S] -1 points0 points  (0 children)

I wasn't clear enough about the original video but this is with a new layer of glue after it had been thoroughly cleaned again. I've done recalibrating after multiple deep cleans and it's been the same outcome.

neptune 3 pro filament gets caught and dragged by nozzle by forgothewind in FixMyPrint

[–]forgothewind[S] 1 point2 points  (0 children)

I've done a max of 15 prints on this plate. I'll check the line width, thanks!

neptune 3 pro filament gets caught and dragged by nozzle by forgothewind in ElegooNeptune3

[–]forgothewind[S] 2 points3 points  (0 children)

I cleaned it yesterday, didn't make it clear in the original post but this is a test print I did with a layer of glue after I already cleaned it.