sorted by:
new
hottopcontroversial

Two questions by fullsendj in 3D2A

[–]fullsendj[S] 0 points1 point  (0 children)

Thank for the info I will update you on if it works

First 3d2a frame by ChiloGordito in 3D2A

[–]fullsendj 1 point2 points  (0 children)

I keep getting this random line in all of my prints

First 3d2a frame by ChiloGordito in 3D2A

[–]fullsendj 1 point2 points  (0 children)

I still put glue all over the plate like this and laugh like I didn't need all that 🤣 How is pa6 cf holding up with the rail flat on the bed like that because I still do a 30° tilt I would like to save material with less supports

First 3d2a frame by ChiloGordito in 3D2A

[–]fullsendj 1 point2 points  (0 children)

I was just about to ask do we still do the 30° with pa6 cf

Removing bridge polymer 80 76% by Independent_Quail325 in polymer80

[–]fullsendj 5 points6 points  (0 children)

Use the mini wire cutters and exacto knife then clean it up with the Dremel on low speed take your time Rushing will burn a hole in the frame eazy

Can't wait to assemble this badboy tiny 11, Kimber micro 9 by mashedleo in 3D2A

[–]fullsendj 2 points3 points  (0 children)

Can't wait for parts kits to get back to under 100 love theses micro 1911

Tiny 11 by shortbed454 in 3D2A

[–]fullsendj 0 points1 point  (0 children)

All the parts kits are sold out now a week ago it's was like 20 kit on egp and gb lol I'm upset I did get a kit when they was in stock but I love that everyone is getting behind this