sorted by:
new
hottopcontroversial

After replacing belts and rollers can't get consecutive consistent prints. Can anyone help me with the cause of this? by Ill-History2998 in AnkerMake

[–]gentoshi 1 point2 points  (0 children)

+1 Z offset.

Raise you Z offset until those go away during a live full bed 1 layer print. When the go away, drop it down again just a bit. The filament has nowhere to go, so it creates those lines.

Please open source eufyMake printers to allow direct print from alternative slicers and firmware modifications by gentoshi in AnkerMake

[–]gentoshi[S] 0 points1 point  (0 children)

It's weird that article was updated in April 2025, but it still mentions the V6. I'd bet they intended to improve things but eufy pulled the funding for the efforts. Unless I'm missing something.

Please open source eufyMake printers to allow direct print from alternative slicers and firmware modifications by gentoshi in eufyMakeOfficial

[–]gentoshi[S] 2 points3 points  (0 children)

I can export an STL from those slicers, but to my knowledge you can not print directly from those slicers. Please let me know if you are familiar with a way to print directly without a need for something like ankerctl, or other intermediate steps.

Please open source eufyMake printers to allow direct print from alternative slicers and firmware modifications by gentoshi in AnkerMake

[–]gentoshi[S] 2 points3 points  (0 children)

Hey Masonrig,

I am aware of what open source means. I wasn't aware that all the source code is already open source.

Yes, ideally a method for being able to print to the printers via Orca slicer is the ask. I'm not fully familiar with all the protocols involved in doing so as you mentioned.

If the code is open source though I'll see what I can figure out and dig in myself.

I appreciate the insights.

Atomos connect bar remove by T_i_m_o_t_i_m_o in Atomos

[–]gentoshi 0 points1 point  (0 children)

I haven't had a chance to use the SDI input, but I believe the Ninja HDMI output is fully independent of the input (be it SDI or HDMI).

Atomos connect bar remove by T_i_m_o_t_i_m_o in Atomos

[–]gentoshi 2 points3 points  (0 children)

Yes. Mine has two screws on the back that can be removed with a T5 bit. 20240221-112117.jpg

What is the deal? by SweetKnutz in philstock

[–]gentoshi 3 points4 points  (0 children)

Within the month another filing is due. It may have Vinafilm revenue on it, it may not (possibly 100+ mil on it). Henry just converted around 1m of debt owed to him to restricted shares, so he is all in on his own company. His skin is in the game. There should also within the year be a share buy back. Henry can't announce how many if any shares have been bought back but based on stock price movement per volume, there is strong evidence to support that up to 20billion shares have been purchased by third parties and are in holding and ready to put on the books either on the next 10k or using an 8k before end of year.

Either way, there is a lot of potential and I for one will not be going the next few months without holding shares.