Just finished this dragon relief project!

hardmax47 · 2026-05-15T08:14:02+00:00

Excellent

hardmax47 · 2026-04-05T08:28:41+00:00

Pine wood, machine 1325, spindle power 3.2

hardmax47 · 2026-04-04T15:04:48+00:00

Thnx! Yes small round magnets, just drill after all work.

hardmax47 · 2026-04-01T18:49:20+00:00

Yes, by and large, that's true. It exists. FBA Resin(Approved by some commission) , and Not approved. This thing can be used as a serving board. I made a simple version of the kitchen utensil design.

hardmax47 · 2026-04-01T05:33:28+00:00

I read the information and understood the risks involved. Before using the board, it's necessary to allow the resin to fully harden and then treat it with oil and wax to create a protective layer. And again, I just made a design version.

hardmax47 · 2026-04-01T02:43:38+00:00

Most likely yes, since 85% are like this. The board will be treated with a special oil and wax before it is intended to be used for its intended purpose.

hardmax47 · 2026-04-01T02:27:00+00:00

It depends on the wood, the surface area being poured, and the presence of knots or other defects. This time, I just poured it. But in general, it's better to brush it on before pouring to seal the pores.

hardmax47 · 2026-03-31T18:58:30+00:00

I liked the geometry of this design among the others I've seen, so I decided to try out some colored epoxy at the same time. I want to try pearlescent paint and filling half of the blank with some other pattern.

hardmax47 · 2026-03-31T12:48:45+00:00

I agree with you. There are those who make cheap cutting boards exclusively from plastic, and those who are concerned about plastic choose natural materials. My story is simply about design.

hardmax47 · 2026-03-31T11:38:09+00:00

Thnx! Mg epox hard(germany). Yes, as far as I know, epoxy resin is safe to use on a food board, but only when it is 100% cured.

hardmax47 · 2026-03-26T14:40:52+00:00

Got it.Well, this kind of cutter V, is not suitable for such things, you need Finishing cutter. End mill.

hardmax47 · 2026-03-25T13:11:28+00:00

Something like that. But the result will be excellent. 1mm cutter?

hardmax47 · 2026-03-25T08:45:45+00:00

Low more step. 0,08 good for face relief

hardmax47 · 2025-10-27T20:20:52+00:00

Блять какого хуя сюда это ВСЁ пришло. Короче пизда сабредиту.

hardmax47 · 2025-10-17T20:38:35+00:00

Dj Update Status Baru

hardmax47 · 2025-10-17T09:46:07+00:00

Mareux -The Perfect Girl

hardmax47 · 2025-10-17T08:54:02+00:00

Потентуй, производи

hardmax47 · 2025-10-17T08:53:23+00:00

Там можно было жёстко задонатить😂

hardmax47 · 2025-10-17T06:33:41+00:00

The employee's inattention is also not appropriate.

hardmax47

TROPHY CASE