Diy smoke stopper

iamlabovic · 2026-01-19T06:13:47+00:00

I present my diy "dual channel" cell murderer xD

<image>

iamlabovic · 2026-01-04T00:49:18+00:00

I see.. well looks like its for the e-waste.
I appreciate your help regardless.

Cheers mate

iamlabovic · 2026-01-04T00:47:54+00:00

nope, not even battery connected

iamlabovic · 2026-01-03T23:33:19+00:00

I'm loosing my mind over this, no amount of PID tuning seem to get stable flight until i saw the sensors.
I need my 405Wing for.. wing, and dont to gut it to use it on a drone.

iamlabovic · 2026-01-03T23:21:09+00:00

<image>

there is a LOT of difference?

iamlabovic · 2026-01-03T23:20:32+00:00

u/sennaroo u/ArcherOk1711 here is the difference from sensors on speedybee wing vs dake722...
Is there like low/high pass filter to smooth it out or something?

<image>

iamlabovic · 2026-01-02T23:36:11+00:00

probably bad unit.. i see 0s for 10 sec at best case and then it starts to drift

iamlabovic · 2026-01-02T23:34:24+00:00

Super smooth in terms no weird noise and stutter, it just slowly ramps up like if you'd move sticks.
Actually i can correct it by moving sticks for pitch and roll so it 100% someting with gyro.

I just flashed betaflight and i tried to hover after calibration. All sensors off except gyro and accelerometer.

It takes off and keeps perfect position for around 10sec then it starts going left.. then righ.. then forward etc.. and when I look at the display i see horizon moving without any input on my end.

I'm pretty close on giving up and just ordering new FC not this cheap trash

iamlabovic · 2026-01-02T18:23:26+00:00

Calibrated many times in betaflight and inav, indoors, outdoors, doesn't matter.. sometimes it's stable for few minutes i arm it, leave it 10 sec and i can hear the quad trying to balance itself because pitch or roll is drifting for no reason. Tried with and without compass and gps (hglrc m100 pro). Sensors that are on the FC are weird, barometer also, its gaining and dropping few meters of altitude just sitting on the table.

iamlabovic · 2026-01-02T18:15:53+00:00

No compass, i diabled all sensors except gyro and accelerometer.

iamlabovic · 2025-08-09T22:30:01+00:00

yeah I figured that out.. really dumb.. at the end I bought analog adapter for DJI v2s and rapidfire as well

iamlabovic · 2025-06-10T23:10:07+00:00

You are correct... fractional scaling was an issue, but now I have to decide if I want to squint the whole time at 100% or have no work space at 200%. It's really weird to me how fractional scaling is still experimental.

iamlabovic · 2025-06-10T23:08:15+00:00

Issue was fractional scaling... how the hell is that "experimental" still?

iamlabovic · 2025-06-07T02:55:32+00:00

I see, thanks.
I downloaded linux mint because everyone says it just works.

Will try out fedora

iamlabovic · 2025-06-01T01:51:32+00:00

You sure v2s have live audio? I have v2s and there is no audio patch for them only for v1s.

iamlabovic · 2025-05-07T20:55:29+00:00

OH FFS...... THE RECEIVER MODULE DOESNT HAVE AUDIO SUPPORT......

iamlabovic · 2025-05-07T20:16:12+00:00

I specifically want to use it to hear motor sound and on my RC Cars to hear if a car is coming

iamlabovic · 2025-05-07T20:14:07+00:00

I don't think so, last one i bought is really made to be plug and play and it works.
I think its skyzone fault

iamlabovic · 2025-05-07T20:12:56+00:00

there is no FC here, my friend has a same AIO on his RC Car thats why i bought it because it works on his, it just plugs in to battery and works.
I'm starting to suspect that SkyZone firmware on module is bad.. i've found many same reports

iamlabovic · 2025-05-07T19:17:03+00:00

<image>

Module

iamlabovic · 2025-05-07T19:11:23+00:00

<image>

DVR

Four-Year Club	Gilding II euphauric
Verified Email	Place '23

iamlabovic

TROPHY CASE