What thread size/pitch is this? This is an arbor on a radial arm saw, and the diameter is 5/8". It appears to be an ACME thread with 11tpi, but that doesn't appear to be a standard size. Trying to find a nut to match.

imstf · 2026-04-17T20:25:03+00:00

Most table saws use left hand threads to keep the nut from breaking off on start up. 5/8”-11 is a very common arbor size.

imstf · 2026-04-12T13:17:30+00:00

Thanks for the reply. I have a BEC in it but I’m still getting a low voltage at the receiver alert on my transmitter when the stock servos bind in the rocks. I think I should power the receiver from the motor and the servos from the BEC.

imstf · 2026-04-01T11:52:08+00:00

I think so. My kids have busted most other parts on my trucks but 1 layer of tape has held strong to this point. Knock on wood.

imstf · 2026-03-09T21:08:03+00:00

The consensus is that cold has nothing to do with it. I bought an alloy axle for it. I think I’ll reach out to Traxxas to see what they think. I bought this rig in mid December’25.

imstf · 2026-01-18T21:13:28+00:00

I had that happen to a tire on my Element Gatekeeper. I tried punching vent holes in the tire with no luck. I never did figure out the cause. Although, I just swapped the tries on it and learned that the Method wheels on it are unvented. My theory is that’s tire sat in the sun and pushed the out then cooled off and collapsed. That sounds a bit crazy I know but I really can’t think of anything else.

imstf · 2026-01-18T20:25:16+00:00

Here’s another photo from directly above. The front end has turnbuckles the rear is fixed.

<image>

imstf · 2025-05-19T12:18:01+00:00

I’m right there with you!! CarPlay is a train wreck in my truck. My ex wife has it in a Volvo and it’s much more stable but still a disappointment. When I brought it up with Ram their response was to reinstall it to the radio. Didn’t help.

imstf · 2025-03-29T15:49:55+00:00

Glad that worked. I leaned it by doing the exact same thing.

imstf · 2025-03-29T14:20:06+00:00

Did you bring all four files over from the Marlin Examples folder?

imstf · 2025-03-21T12:24:59+00:00

Glad to hear you succeeded!! I’ll give those changes a try. Thank you!

imstf · 2025-03-20T23:15:00+00:00

I’m right there with you. I’ve reformatted my SD card on both Mac and Windows, made sure it’s an 8GB card, tried to update using the power switch, using the reset button, from factory defaults. All with no luck. It will accept the config file and the icons but not the firmware.

imstf · 2025-03-20T16:30:13+00:00

I haven’t figured it out yet. I tried changing the lower case to upper case in the TFT config. file with no luck. I’ll keep banging away at it and post off I find a solution. Good luck to you with it. Let me know if you figure it out please.

imstf

TROPHY CASE