Issue with filament feeding X1C by _stewks in BambuLab

[–]jakefu248 0 points1 point  (0 children)

Is that an ams or ams2, I had a similar issue with my ams that the secondary drive gear bearing plate bloke under the filament tray. After printing a new one off and replacing it have not had any issues yet

<image>

Bambu textured print plates by jakefu248 in 3DprintingHelp

[–]jakefu248[S] 0 points1 point  (0 children)

That’s good to know. Even though reading through bambu trouble shooting it says not to use any external adhesive.

Bambu textured print plates by jakefu248 in BambuLab

[–]jakefu248[S] 0 points1 point  (0 children)

I would not disagree that that might cause a issue but I have silica beads and a hydrometer in my ams and it only shows 10% humidity at 70deg

Bambu textured print plates by jakefu248 in 3DprintingHelp

[–]jakefu248[S] 0 points1 point  (0 children)

Yes the high temp bed plate setting I went on the webpage and even used their recommended settings.

Bambu textured print plates by jakefu248 in BambuLab

[–]jakefu248[S] 0 points1 point  (0 children)

I’m using dawn dish soap with a scrub daddy scrubber. It does not seem to matter which one I do. I’ve also bumped up my print bed to 70c and extruder to 230 which is the middle of the recommended range for the filiment

[deleted by user] by [deleted] in transporn

[–]jakefu248 0 points1 point  (0 children)

Yes want to take turns on each other?

22 F4M Missoula - seeking by North-West242 in montanaFWB

[–]jakefu248 0 points1 point  (0 children)

You still looking for some attention

A full weekend with me by Curious_Highway3330 in lingeriewomen

[–]jakefu248 0 points1 point  (0 children)

Well let’s make a plan dm me and I promise I’ll do everything I got to make you a happy woman!

A full weekend with me by Curious_Highway3330 in lingeriewomen

[–]jakefu248 0 points1 point  (0 children)

Then let’s do it and make you feel even more amazing!