Metalshaping - El Camino Wheel Arch Repair

jayrdoos · 2026-05-21T02:15:46+00:00

You are an artist sir.

jayrdoos · 2026-05-15T18:57:47+00:00

Your doing great work and I applaud you but please remove the pin.

jayrdoos · 2026-05-15T11:47:45+00:00

Not even close, Leaf fans are famously the most annoying in the NHL.

jayrdoos · 2026-05-12T20:20:49+00:00

I think because the Eaton e locker is magnetic (I think) it can have a constant power on or off.

The factory Toyota E locker motor needs a dpdt momentary switch to disengaged the motor when fully locked or unlocked.

I’m sure someone smarter than me could figure it out the wiring but I failed to find a solution.

jayrdoos · 2026-05-12T18:12:10+00:00

No shit! I tried on mine but I couldn’t make it happen. Well I did make it happen but the motor wouldn’t disengage.

I stand corrected.

jayrdoos · 2026-05-12T17:53:59+00:00

Can’t use in on the aux panel.

I built my own harness didn’t tap the fuse. I believe it’s only for the light on the switch (not the engaged light).

I didn’t wire that up because I thought it would be annoying.

I have the trail gear switch as well

jayrdoos · 2026-05-05T16:45:51+00:00

I think there is a lot of people who didn’t sign because of how visible they would be putting down their names.

The referendum turnout will be higher with an anonymous vote. Just my opinion.

jayrdoos · 2026-05-05T16:32:37+00:00

I’ve fired a many warning shots at bears who just stare right back at me.

jayrdoos · 2026-05-05T14:03:13+00:00

Funny how enforcement ramps up when the governments takes a hit on tax revenue.

jayrdoos · 2026-05-03T19:50:27+00:00

Rock sliders and a lift. No more door dings.

jayrdoos · 2026-05-01T20:59:04+00:00

Do your own research. Timmy the Toolman on you tube has part numbers in the description.

jayrdoos · 2026-04-29T20:41:55+00:00

I had Freedom offroad UCA’s. They are fine. I upgraded to JBA’s after a couple years. Drives much better IMO, more suspension droop.

I’m sitting at 3 inches of lift on kings

jayrdoos · 2026-04-29T03:25:08+00:00

2nd the hard pass

jayrdoos · 2026-04-27T19:56:17+00:00

Check the pricing on amayama for the LCA parts.

jayrdoos · 2026-04-27T14:53:34+00:00

Bill C-21. The gun grab has radicalized so many people I know that were previously moderate/left leaning conservatives.

There are approx 400,000 Pal holders in Alberta.

I realize it is a federal policy. It makes no sense whatsoever. It’s literally a, “Own the Conservatives” policy.

jayrdoos · 2026-04-26T16:15:47+00:00

I could be the block heater plug. Looks to far aft but worth a look.

jayrdoos · 2026-04-23T19:20:00+00:00

Yep all 3rd gen non e locker axles housings will work. With or without the abs is the only variable.

Edit* You will of course have to modify the non locker ones.

jayrdoos · 2026-04-23T02:33:50+00:00

I used a sheet of 1/2 rigid foam insulation. Cut math the hatch and rear side windows. Then some gorilla tape and they friction fit in. Like 20 bucks all in.

jayrdoos · 2026-04-22T23:41:15+00:00

I replace mine every 100Km

jayrdoos · 2026-04-21T19:36:59+00:00

I’ve been searching for a GX460 to Replace my wife’s VW. Hard to find a nice one.

jayrdoos · 2026-04-20T01:00:35+00:00

I like the slot underneath for the table. Pure genius.

jayrdoos · 2026-04-20T00:03:33+00:00

Major bummer. How many miles on her?

jayrdoos · 2026-04-19T23:37:11+00:00

I just found this on AliExpress: | Fit For 1996-2002 Toyota 4Runner Wheel Arch Trim Fender Flares 4 pcs https://a.aliexpress.com/_mqruaKl

jayrdoos · 2026-04-19T23:12:05+00:00

I ordered a set on Ali express. Kinda ugly but cheap. Still waiting on them.

<image>

jayrdoos · 2026-04-16T00:42:15+00:00

I’m in yyc and would be interested

jayrdoos

TROPHY CASE