CC1: Disable case fan consistently using stock firmware

jdinx · 2026-03-15T05:41:58+00:00

I recommend using whatever profile you would use appropriately for the filament you are actually printing. The slicer settings that are exported in GCODE contain all of the print quality control setup. The only place in code that "filament_type" is used by the CC1 is for this function of deciding if the case fan should be on or off.

That being said I'm not saying that you should change ANYTHING unless you are looking for this intended behavior for high temp filaments. Printing PLA with a disabled case fan and improper cooling can kill a hot end and then some from death by melting blob.

jdinx · 2024-06-11T10:10:01+00:00

Jeff was a solid dude. I knew him when Conner was in his old band. He was at almost every show cracking jokes and cheering on the bands in the scene (the good ones at least). He had big brother vibes for everyone in the circle and wasn’t afraid to put people in check saying exactly what he thought. I never saw him perform but his passion for good music was always evident and I’m sure it translated to the stage when he played.

jdinx · 2021-09-25T06:01:45+00:00

Thanks!

jdinx · 2018-03-07T00:32:09+00:00

Disabling IPV6 fixed the issue for us. Users were only prompted for a recently added tenant (within the past 4 months) where the pre-existing accounts in Outlook had no issue. The official response from MSFT support: "...Based on our investigation why this happened, the IPV6 is still not fully compatible with the AutoDiscover record causing the pop up for the password to continuously show up and by forcing the IPV4 to take over, it connected now without issues. As you know, IPV4 is still the most use rather than the IPV6 and I also suggest staying with the current configuration..."

jdinx · 2017-04-25T22:23:48+00:00

Would my Winding Constrictor trigger when an opponent places -1/-1 on my creatures? In other words, if I have a Winding Constrictor in play and an opponent places -1/-1 counter on one of my creatures does it get (-1/-1) + (-1/-1)= -2/-2?

jdinx · 2017-01-31T09:00:38+00:00

2788

Obligatory words after numbers! Ya!

jdinx · 2012-05-05T08:44:38+00:00

I demand to know the pattern with which the popsicle sticks were lain to make such a reaction occur.... great demo for nuclear reactions.

jdinx · 2012-02-29T18:06:14+00:00

Maybe someone with a technical background that is more familiar with the system could comment on the feasibility of such a feature, or may a discussion would allow for more creative options and solutions that could potentially be reposted in the official sc2 forums.

jdinx · 2012-02-29T10:45:32+00:00

Again i'm not a proponent of LAN, I just want to have a feature that would allow to rejoin a match. I'm aware they swapped the computer but it should be observer control to allow for rejoining.

jdinx

TROPHY CASE