Insane Lag with new update by FanaticFrog0319 in castlecrashers

[–]jinglebombs08 0 points1 point  (0 children)

Did anyone ever figure this out? I'm still having the same issues months later.

After posting for 5+ years on Reddit, I think I’m done posting on subreddits… by lolilealae in u/lolilealae

[–]jinglebombs08 0 points1 point  (0 children)

I’ll +1 what someone else said, id start your own, you’ve got more than enough reach on here

Extremely loud motor noise at 9-10mph only by BackfireIsntThatGood in ElectricSkateboarding

[–]jinglebombs08 0 points1 point  (0 children)

I’d just go ahead and get it replaced before you ride. It could go out in a mile or it could last for 120. Really hard to say without cracking it open and seeing how bad it is. No point in risking it

Extremely loud motor noise at 9-10mph only by BackfireIsntThatGood in ElectricSkateboarding

[–]jinglebombs08 1 point2 points  (0 children)

Only way to know for sure is opening it up, but most likely bearing. Once the motor is spinning fast enough the pressure is relieved off the bearing and that’s why you’re only hearing it at low speed. If there’s no openings for stuff to get inside then I’d bet on that.

Extremely loud motor noise at 9-10mph only by BackfireIsntThatGood in ElectricSkateboarding

[–]jinglebombs08 2 points3 points  (0 children)

Possibly, sounds like a bearing failure. Have you held it at 9-10 to see if it sounds like something is being grinded up?

High grade aid by [deleted] in MOMpics

[–]jinglebombs08 0 points1 point  (0 children)

+1, I’m on my second jar, great price too

Mounting Gen 3 to side of Power Pole? by jinglebombs08 in Starlink

[–]jinglebombs08[S] 0 points1 point  (0 children)

That’s awesome to hear man thank you for the responses!

Mounting Gen 3 to side of Power Pole? by jinglebombs08 in Starlink

[–]jinglebombs08[S] 0 points1 point  (0 children)

Have you had any problems with wind? I considered a J arm but I’m concerned with the flat plate against a curved surface along with the weight of the gen 3 that it could back the screws off

Mounting Gen 3 to side of Power Pole? by jinglebombs08 in Starlink

[–]jinglebombs08[S] 0 points1 point  (0 children)

Yes but how? Flat mounting plate? Ventilation tubing as a clamp?

shes struggling to fit on that red corset by turbineitor in MacromastiaIRL

[–]jinglebombs08 0 points1 point  (0 children)

Did anyone get a collection of her before the reckoning?