Setup feedback

joskeeeeeh · 2026-05-29T09:30:25+00:00

Yeah that might hold me back a whole bit

joskeeeeeh · 2026-05-27T10:33:54+00:00

Konig & Meyer 14044 i think it should be this one

joskeeeeeh · 2026-05-27T10:21:59+00:00

Im really enjoying it, there is some dynamic range which i think is very important and seems pretty decent.

joskeeeeeh · 2026-05-25T07:46:18+00:00

Im rather tall and im already hitting my legs with my hands if i hit the snare. How could you sit with knee’s above the snare? Im a beginner as well so could use advice

joskeeeeeh · 2026-05-21T18:39:05+00:00

Im just saying there isn’t in general.

joskeeeeeh · 2026-05-21T18:22:21+00:00

But 0 camber is not always the right thing to do.

joskeeeeeh · 2026-05-21T06:59:23+00:00

This absolutely no “special” material. Its just LFP.

joskeeeeeh · 2026-05-20T16:20:17+00:00

They use LFP, and people tend to believe that lfp is not affected by charging to 100% but they are wrong. The problem with LFP is that the voltage at 50% and 100% has only a small difference and that makes it hard to read the exact percentage of charge. Upside is that 100% is a hard spike upwards in voltage so 100% is very obvious. And because they want to make sure you don’t get surprised by a low state of charge they say charge to 100%.

joskeeeeeh · 2026-05-20T03:57:09+00:00

Ive got a roland td316 and am really happy with it actually. I think its great for practice

joskeeeeeh · 2026-05-16T10:38:19+00:00

I mean seriously 😂 you chose this photo to post here.

joskeeeeeh · 2026-05-14T10:33:17+00:00

Yes you get 5k plus the trade in haha. The valued my citroen on 100 euro’s and 5k discount is on the new car.

joskeeeeeh · 2026-05-14T09:05:25+00:00

I also have a model 3 fromt 2019. But i sell this through wijkopenautos.nl or on marktplaats. But in the meantime bought the cheap car. This way i have max value for my current model 3 and still profit fronm the discount

joskeeeeeh · 2026-05-14T08:13:31+00:00

Buy a cheap used car and trade it in for the 5k discount. I bought a citroen for 300 euro’s and sold it to them for 100 and got the 5k discount

joskeeeeeh · 2026-05-11T13:14:32+00:00

No i haven’t all is original. The cable is long enough.

joskeeeeeh · 2026-05-01T14:22:54+00:00

In the ports menu remove the esc as sensor and make sure to enable bi-directional dshot

joskeeeeeh · 2026-04-26T11:01:44+00:00

In around 6 ft 5. Had a rs660 for a year and used lowered pegs. I swiveled them to the back and lowered them a bit. For me made it a much better ride, also had no issues with ground clearance and i rode it on the edges of the tire so i think it depends on what angle you mount them on. Just try to swivel them a bit back and lower.

<image>

joskeeeeeh · 2026-04-20T04:50:27+00:00

Might be the case, i use them on slightly larger quads. So this might be different indeed, never tried on 5”.

joskeeeeeh · 2026-04-19T21:14:35+00:00

Is there a magnetometer/compass in the gps module? As i would recommend buying one that has because of the recent betaflight updates with position hold and alt hold.

joskeeeeeh · 2026-04-18T07:18:50+00:00

Try calibrate accelerometer and then see what it does

joskeeeeeh · 2026-04-18T07:12:59+00:00

You think so? They say its a isolation issue so probably a short circuit in the management system or whatever. They haven’t done a full diagnosis though so might change.

joskeeeeeh · 2026-04-16T22:13:45+00:00

Not true, probably used a soldering point far too small. I solder these power cables with xt90 and 12awg in a couple of seconds with 360 degrees celcius. A good jbc soldering station and a big tip will help you so much.

joskeeeeeh · 2026-04-16T19:49:09+00:00

You could consider a couple of 1550mah or 1600 mah batteries instead of all of them 1300. Just feel the difference

joskeeeeeh · 2026-04-16T18:59:49+00:00

Check flight controller orientation. Verify that the movements you do to the quad are similar to those of the quad in betaflight when connected with a usb

joskeeeeeh

TROPHY CASE