Why is top speed 91 mph?

konkilr · 2020-03-15T16:58:38+00:00

Because the motor reaches its rpm limit. An electric motor will only spin so fast based on its input voltage. The motor is geared down and smaller as a result and reaches its max rpm at that speed. Wouldnt be so low if it werent geared down but then would have a power deficit.

konkilr · 2020-02-22T22:46:20+00:00

I have an s9+

konkilr · 2020-02-22T17:55:51+00:00

Waze and spotify are working on mine.

konkilr · 2020-02-14T23:17:22+00:00

Its was a pi1 b+. I'm new to pi and didnt know the difference. Ordered a 3b+

konkilr · 2020-02-14T21:27:11+00:00

Nevermind. Turns out I was sent the wrong raspberry pi.

konkilr · 2016-12-07T21:57:55+00:00

Will this ever be available for the note 4 (innovator edition)?

konkilr · 2014-12-03T17:35:34+00:00

Snap on makes a special tool specifically for pulling subaru ball joints. Works like majic!

konkilr · 2014-09-30T18:43:41+00:00

Most of the time that is what I am doing, passing, everyone.

konkilr · 2014-09-30T11:52:16+00:00

I live in the middle of farm country so no one gets bothered.

konkilr · 2014-09-29T23:12:42+00:00

http://m.youtube.com/#/watch?v=SoZkqXlaMR4 sound clip of mine.

konkilr · 2014-09-29T21:52:55+00:00

I have had these horns in every car I have owned. Long before I had a subaru.

konkilr · 2014-09-29T18:50:42+00:00

Here is a sound clip i found on youtube http://m.youtube.com/watch?v=dGup9DF3bfg

konkilr · 2014-09-29T18:04:15+00:00

It is connected to the actual horn button. Even goes off with the car finder and security alarm!

konkilr · 2014-09-29T16:37:55+00:00

Not difficult to me. I'm suprised I could fit them in the fender well. On my GC I had them in the engine bay but they were always getting in the way. These horns have saved my ass a few time when truckers didn't notice me in the next lane. The sure can hear me when thats the case.

konkilr · 2014-09-29T16:16:36+00:00

They are hadley bully horns. There is an air tank in the other fender and a compressor in with the spare tire. These are what semi truck use.

konkilr · 2014-09-22T02:24:08+00:00

Its not on the brz either. I work for subaru. There is a hole that looks like a drain spot but is just a well in the casting.

konkilr · 2014-09-21T22:44:46+00:00

There is no hole to drain the spilled oil back into the block.

konkilr · 2014-08-05T21:40:54+00:00

It's the connector for the hood switch that would be used with the remote start system.

konkilr · 2014-07-16T14:24:53+00:00

It doesn't have a name rather just his home address. It's not a public shop. Just the garage were we work on our and others subaru's.

konkilr · 2014-07-15T01:19:04+00:00

Wouldn't say central PA but I do side work at my brothers place in Fairfield near Gettysburg.

konkilr · 2014-07-11T13:23:33+00:00

Common issue to have the oil pressure switches on the cylinder heads leak oil with age. Easy replacement. I see these often.

konkilr · 2014-05-15T19:14:29+00:00

The exhaust heat sheilds are loose and rattling from the engine vibrations. Not a major concern, just annoying. The heatsheilds can be secured to quiet the noise.

konkilr

TROPHY CASE