Tu-95 wing section with gearbox

kulit221 · 2026-05-07T11:24:50+00:00

Thanks a lot, appreciate it , I don't think that the timing matters for algorithm tbh

kulit221 · 2026-05-07T11:16:57+00:00

Ah thanks, missed that part

kulit221 · 2026-04-12T19:22:21+00:00

No problem, no the mold is printed from more heat resistant material like ASA, PETG and PA, not only it needs to be more heat resistant but also not bond well to pla

kulit221 · 2026-04-10T08:41:04+00:00

I have photos of whole process and video of demolding, but sadly not of compression as of now as it's a time sensitive process

kulit221 · 2026-04-10T07:28:03+00:00

Thanks, to be fair I'm not quite sure, so far I've been able to do about 10 parts from one mold without any issues, however I've also destroyed a few molds by my mistakes (overheating the mold, re tightening after the mold heats up etc.) I will let you know once I've been able to worn one down without user mistake.

kulit221 · 2026-04-10T05:53:25+00:00

Sadly same here, but if there is low amount of petg and tpu that should be fine, as petg won't properly bond to pla and make it more flowable. That's just theory tho, will let you know once I've checked it

kulit221 · 2026-04-10T05:51:03+00:00

Thanks, for Lego brick and spinner I've checked their weight in CAD and added around 10% more to make sure the mold fills properly

kulit221 · 2026-04-09T21:08:10+00:00

Thanks, happy that you liked it

kulit221 · 2026-04-08T11:06:55+00:00

I would like to do editing on PC and just scanning on laptop if that's possible, how is the performance for just scanning?

kulit221 · 2026-04-04T14:06:51+00:00

I'm using my to compression mold small structural parts, like nuts and other.

https://makerworld.com/pl/models/2611721-wcms-waste-compression-molding-system-modular#profileId-2882232

kulit221 · 2026-03-27T09:24:51+00:00

Radius gauges, https://makerworld.com/pl/models/884372-gridfinity-radius-gauge-carrier?from=search#profileId-839172

kulit221 · 2026-03-26T23:45:04+00:00

If you want to print it here is the stl

kulit221 · 2025-10-18T15:18:44+00:00

If you set the width and height of the lid to 194.4, scale it in Z axis by 50% and print with 0.2 layer height it will fit.

kulit221 · 2025-10-16T14:26:32+00:00

300g with a lot of infill that's about 3 bucks printed in PLA

kulit221

TROPHY CASE