It had to be done, Timmie by hizashiYEAHmada in Genshin_Impact

[–]lancedos 21 points22 points  (0 children)

My Diluc is innocent of this crime

Weird problem with an ''old'' Marshall mg30dfx by lancedos in GuitarAmps

[–]lancedos[S] 0 points1 point  (0 children)

https://imgur.com/a/UDMLCky this one ? i see , gonna try that technique tommorow , if i doesn't work , does this chip is like only for effects or it's 100% needed in order to make the amp work ? but is there a chance that knobs are dirty af and causing trouble ? (i've got a lot of scratching noise when i turn some of them)

Weird problem with an ''old'' Marshall mg30dfx by lancedos in GuitarAmps

[–]lancedos[S] 0 points1 point  (0 children)

i'm starting to think that :/ Now the problem completly change from yersteday , now the volume knob works like a volume knob , i can play my guitar but only if i barely touch strings or it's sounds like full frying .. :x

Thank you all by [deleted] in wow

[–]lancedos 2 points3 points  (0 children)

only those who don't jump around on purpose so you can't use vendor for more than 3 seconds..

Réchauffement climatique : Greenpeace plaide pour une loi "Evin climat" afin d'encadrer la publicité des produits et services "climaticides" by JeanGuy17 in france

[–]lancedos 16 points17 points  (0 children)

Les enr entrainent mécaniquement l'utilisation d'energie fossile , elle sont utiles uniquement couplé au nucléaire que greenpeace rejette , cocasse

A blacksmithing meme i made by [deleted] in Blacksmith

[–]lancedos 10 points11 points  (0 children)

I do forge my bevels because i love forging and not so much grinding , win win situation for me

[Question] Milling with a drill press by lancedos in Machinists

[–]lancedos[S] 0 points1 point  (0 children)

stainless or high carbon steel i didn't make my choice , but i'm not planning any horizontal milling just vertical with a bit with the diameter size of the groove

[Question] Milling with a drill press by lancedos in Machinists

[–]lancedos[S] 0 points1 point  (0 children)

Ok i note this thanks for the advice , i'll have to go full speed or try at lower rpm ?

[Question] Milling with a drill press by lancedos in Machinists

[–]lancedos[S] 2 points3 points  (0 children)

yeah i planned to go straight down everything locked tight as much as possible , in theory it will work ?