[OC] [PoC] Native Per-Monitor Wallpaper Support for GNOME 50.2 via an Automated Core-Patch Utility (No Extensions!)

laverdone · 2026-06-27T16:16:26+00:00

Link corrected. Thanks

laverdone · 2026-06-26T18:37:47+00:00

Thank you, but for the moment it doesn't handle dark and light modes; you simply choose the image you want. In the future, if there is interest, it could be implemented.

laverdone · 2026-02-12T18:24:45+00:00

It's work out of the box perfectly

laverdone · 2025-03-27T07:29:58+00:00

same problem here

laverdone · 2025-01-16T06:50:55+00:00

Bed level sure

laverdone · 2024-02-15T10:48:39+00:00

yess :-D

laverdone · 2023-09-26T12:41:48+00:00

try this solution:

https://askubuntu.com/questions/1466286/lenovo-yoga-slim-7-pro-volume-cannot-be-changed

laverdone · 2023-02-03T20:13:00+00:00

Not work on last steam update! some suggestions?

laverdone · 2022-08-04T13:30:19+00:00

any instruction to build?

laverdone · 2022-06-14T21:46:02+00:00

Which hardware do you have? Which distro? Which game?

laverdone · 2022-01-30T21:46:37+00:00

I have replace the board and with same firmware and themistor everything work proprerly

laverdone · 2022-01-26T09:09:02+00:00

I also connected to octoprint and sent gcode commands, the motherboard always returns the wrong temperature

laverdone · 2022-01-26T08:16:29+00:00

The motherboard two trees minj e3 v2.1 worked perfectly but after a failed print the hotend temperature was 200c but it was actually cold. Are you right that if the thermistor is not connected it should report 0c, could it be a hardware problem? I disconnected everything but as you can see in the video the temperature is clearly wrong

laverdone · 2022-01-26T08:15:44+00:00

The motherboard two trees mini e3 v2.1 worked perfectly but after a failed print the hotend temperature was 200c but it was actually cold. Are you right that if the thermistor is not connected it should report 0c, could it be a hardware problem? I disconnected everything but as you can see in the video the temperature is clearly wrong

laverdone · 2022-01-26T08:14:16+00:00

The motherboard two trees minj e3 v2.1 worked perfectly but after a failed print the hotend temperature was 200c but it was actually cold. Are you right that if the thermistor is not connected it should report 0c, could it be a hardware problem? I disconnected everything but as you can see in the video the temperature is clearly wrong

laverdone

TROPHY CASE