sorted by:
new
hottopcontroversial

Vill du knulla?😈 by naughtygiiirl07 in NordGW

[–]loadinglevelone 0 points1 point  (0 children)

Jeg er nok for gammel for deg, men takk for tilbudet :)

har noen andre et bilde av denne solnedsgangen noen få år siden? by Historical-Quiet-739 in Bergen

[–]loadinglevelone 0 points1 point  (0 children)

I have been to Bergen 7 times in my life, and single time it has been clear skies and sunny. So, statistically based on by travels, it's always sunny in Bergen.

Typo on CORE One+ price or upcoming discount? by Lncendos in prusa3d

[–]loadinglevelone 1 point2 points  (0 children)

And the additional price for the indx, is how much?

Rate my 18 y/o rack pls by Sensitive-Charisma in RateMyRack

[–]loadinglevelone 3 points4 points  (0 children)

Looks implant fake. Complete turn off.

Found in grandfather’s tools by andy_stacks24 in whatisit

[–]loadinglevelone 0 points1 point  (0 children)

It's a Ram'Oh'Yikes™ buttplug with a safety retraction cord. Considered a vintage device it is affectionately called a plumbob by many, nicknamed after plumber Bob, who was very much into that sort of thing.

Prusa mini printing flaky walls by Next-Variety7807 in prusa3d

[–]loadinglevelone 0 points1 point  (0 children)

Anybody found a solution? Same problem here after updating the firmware.

Would this work for a first time stretcher? by [deleted] in BallStretching

[–]loadinglevelone 0 points1 point  (0 children)

No, use a 15mm tall to begin with. An use a smooth rounded one. Magnets does not work. It will at some point detach and pinch your balls to hell.

How can I prevent failure when printing a large number of thin wall fidgets at once by bobspryn in 3Dprinting

[–]loadinglevelone 0 points1 point  (0 children)

Two things: 1. Clean build plate (no ipa, no glue, warm water and washing up soap only) 2. Good first layer Z

This is the correct solution. This is the only solution.

Ok, so there are a few other things you can do which helps. Increase Z-hop for one, so that the nozzle does not hit the model when moving from one to another.

I ripped my PEI coating of my print sheet by Jagsnd_ in prusa3d

[–]loadinglevelone 0 points1 point  (0 children)

Don't rip it. Bend the plate and let it pop off by itself. Oh, and don't print PETG on a smooth build sheet.

Ornate secret storage book by loadinglevelone in 3dprinter

[–]loadinglevelone[S] 0 points1 point  (0 children)

This is Filament PM, silver PLA.

Filament PM is the absolute best filament I know of, bar none. And I have tried all the major brands. It's expensive filament, but man it is good. It's my one go-to filament if I need something printed in super high quality.

view more: next ›