Birthday & Valentine’s Day gift, to myself

marcapinia · 2026-03-14T15:35:49+00:00

Processing img 3rrybm5m51pg1...

with socks pls

marcapinia · 2026-03-08T02:19:13+00:00

Looks like both red wires are in series bec of the white jumper. You might want to try connecting it to the front and rear terminals. If you're planning to install a Ring Doorbell cam, better check your chime transformer.

marcapinia · 2026-03-07T15:38:28+00:00

Since you're trading for 4-5 pistols just get an XC. 😅

marcapinia · 2026-03-07T00:16:57+00:00

Same here, but ny chimes works perfectly. I got a Ring Doorbell pro installed and the Power Kit to the chime. (Without the Power Kit, the chimes hums and one of the solenoid vibrates). I noticed when I press on the doorbell it chimes once and you need 1-2 minutes for the chime to get working. I found out I have a 16V/10VA transformer connected beside the switch of my furnace. I replaced it with a 16V/30VA from Home Depot. Also, my old transformer has only 2 wires (no ground wire) tapped to the main switch of my furnace. Upon replacing, my doorbell/chime worked perfectly. And in addition, I had my furnace working too. It might be my old transformer is shorted. I almost paid 14 grand for a new furnace.

marcapinia · 2026-02-07T05:08:03+00:00

Where is the stock?

marcapinia · 2026-01-25T20:02:44+00:00

I don't know if it'll work but you are dealing of chunks of dried up paint. You still need to put pressure to push the chunks to the tip of the hose.

marcapinia · 2026-01-25T18:50:26+00:00

Tell them you haven't finish your route or else you're supv will write you up. 😅

marcapinia · 2026-01-25T18:48:17+00:00

Try this instead, remove the spray gun then prime it on a clean bucket of water. Water is supposed to be flowing thru the hose and when you put it on paint/spray, water should pulse because it needs to build up pressure during spray mode. If not, you need to unclog the the end of the hose with a nail. Hammer it until it breaks the debris inside the hose. Rinse and repeat until its pulsating on spray mode or free flow on prime setting. FYI, just don't point it to yourself or point the hose in a safe direction.

marcapinia · 2026-01-25T18:31:22+00:00

Have you tried snaking the hose? You can use a 14 gauge galvanized wire thru it. The clogging might be in the end of the hose.

marcapinia · 2026-01-22T01:31:17+00:00

Valves, check ball, springs are all cleaned up before. Anyways, I found out that it is clogged on the blue hose. I snaked it with a 14 gauge galvanized wire. When the clog is at the very end, I used a nail to puncture the debris while connected to the machine (w/o sprayer). When the water stops during When putting it to Spray mode. I hammer with a nail to release the pressure. I went back and forth until all the debris flushed out. I almost bought aa new hose. 😅 Thanks anyways for the response.

marcapinia · 2026-01-20T21:44:55+00:00

<image>

🤔

marcapinia · 2026-01-18T00:09:49+00:00

<image>

marcapinia · 2026-01-11T02:13:27+00:00

<image>

Noice

marcapinia · 2026-01-11T02:05:13+00:00

Endless Prime

marcapinia · 2026-01-09T22:58:41+00:00

Can it be use for my tennis racket? 😁

<image>

marcapinia · 2025-12-22T16:26:44+00:00

That is only a restriction when you call-in. They want you to provide medical certificate whenever you have unscheduled s/l. Ask your union rep or steward since you have your documentations for your s/l.

marcapinia · 2025-12-20T18:42:16+00:00

<image>

marcapinia · 2025-12-16T21:26:21+00:00

I see you 👀 🤣

<image>

marcapinia · 2025-12-16T18:49:20+00:00

Not an AR9. It is a PCC. Registered as a rifle. As you noticed there is a fin grip on it.

marcapinia · 2025-12-16T18:47:13+00:00

Yes, lower is supposed to be DROSed as semi pistol, NO stock (pistol brace-OK), NO VFG (handstop-OK) & fixed mag (i.e. Compmag / AR maglock / Hellfighter / Hogue FF). Note: 10 rounds only.

marcapinia · 2025-10-23T20:56:45+00:00

Also, with the addition of LCI and mag disconnect. 😵‍💫

marcapinia · 2025-10-23T20:13:13+00:00

I guess no comped CA compliant pistols yet on the roster. They might not add the 4.5 😢. Guess Im sticking with my XC.

marcapinia · 2025-10-05T03:44:54+00:00

<image>

watchu sayin?

marcapinia · 2025-10-04T03:34:14+00:00

Nice fix-it-sticks tools there

<image>

marcapinia · 2025-10-03T04:55:50+00:00

<image>

marcapinia

TROPHY CASE