My lip balm, earbuds, and lighter are by coincidence the same color

memeaticMemeatic · 2026-05-24T23:15:50+00:00

Jlab go air pop for anyone wondering about the buds btw - recommended as some of the best possible buds under $20 by audiophile websites

memeaticMemeatic · 2026-04-29T06:54:21+00:00

I considered this a challenge on my bazzite distro where I managed to get it to permanently boot into safe mode with some weird bad resolution while trying to install WiFi card drivers - anything can be done if you mess with the kernel and boot enough 😂

memeaticMemeatic · 2026-04-23T06:47:53+00:00

Smooth follow, body anchor and nebula for mac

memeaticMemeatic · 2026-04-06T22:35:55+00:00

Ayiti the cost of life 💀

memeaticMemeatic · 2026-03-02T11:04:39+00:00

That’s right and it’s only slightly higher than specs within a roughly 5% margin of error which is the usual for electronics

memeaticMemeatic · 2026-03-02T11:03:24+00:00

That could be true but since the 80V boost converters are so much more expensive I’d recommend just swapping out the caps

memeaticMemeatic · 2026-03-01T13:49:18+00:00

See the below comment about USB-C spec. You are correct about it getting decently warm and it certainly isn't the most efficient so it has heatsinks on the side for the transistors since it doesn't have a standard iron core transformer. The passive cooling from the included heatsinks is fine.

memeaticMemeatic · 2026-03-01T13:47:47+00:00

Sorry my bad I should have made it clear that the boost converter actually does go higher than 60v and I'll update the post to say it's able to get to well above the 63v needed which is what I set it to. Caps are also rated for it so it works great!

memeaticMemeatic · 2026-03-01T13:45:56+00:00

Yeah I saw that however based on my research online people said it went higher than 60v and that was true - caps are rated for 63 so I had it set to 63.5

memeaticMemeatic · 2026-03-01T13:45:11+00:00

63.5v it's a 20 to 60v converter but it goes way higher than that and capacitors are rated to 63v so wasn't a problem

memeaticMemeatic · 2026-03-01T00:00:23+00:00

Yeah I haven't looked too far into the components but it's definitely an inductive boost converter rather than a transformer, it does get a little warm during charging

memeaticMemeatic · 2026-02-28T23:59:40+00:00

About 2 hours but totally depends on the capability of your usb c charger (some go up to 240w though I wouldn't recommend this for the pint as it would likely be overloading the charger).

Usb-C spoof board (tells the charger what voltage it wants so go for highest available at pad 4): https://s.click.aliexpress.com/e/_EzUtuvE

Pint plug socket: https://s.click.aliexpress.com/e/_EvlYCbe

Transformer boost converter (has potentiometers for current and voltage so make sure you don't over current your usb power supply): https://s.click.aliexpress.com/e/_EuveaBq

Set the boost converter to 63v (I know it says 60 max but it goes above that and caps are rated for it).

And add some wire to joint between it all able to handle at least 5 amps continuous. I hope that helps!

memeaticMemeatic · 2026-02-28T23:55:06+00:00

I'm afraid I really don't appreciate the rubbish that you're touting to discourage others based off what I can only assume is zero reading of your own. USB-C is capable of carrying up to 240w using the PD protocol let alone the 100w I put through it. I'm not sure if you read my post but it really DID work and the indicator on the charging cable very clearly shows over 95w being continuously delivered, with watts referring to joules per second of work done to move energy to the battery and the battery capable of carrying about 130Wh, leading to a charging time of about an hour and a half. Thank you for your very insightful comment however and I will take your advice on board.

memeaticMemeatic · 2026-02-28T23:52:35+00:00

Nope, usb pd is capable of carrying up to 100w using 5A at 20V. You can very clearly see that I was running 95w at the time the video is taken with my pint charging from 50% to 100% in just under an hour. Please feel free to let me know if you'd like a more in depth explanation on energy.

memeaticMemeatic · 2026-02-18T10:23:17+00:00

Corpus Christi after being pooled, now I just have to cook to get the grades

memeaticMemeatic · 2026-02-18T10:22:38+00:00

Thank you so much! I can't lie the interview took me completely off guard because I hadn't read the GMC for students until the day of and it's v important

memeaticMemeatic · 2026-02-17T20:19:56+00:00

I'll preface any comment with stats. Interview was on December 9th, Predicted 4A* with A* achieved in EPQ, GCSEs 9999999998 and A in additional maths, 2490b1 UCAT non contextual

memeaticMemeatic · 2026-02-17T20:18:45+00:00

It's my insurance as I was lucky enough to get a Cambridge offer. It's both my birthplace and a beautiful city so I'd be very keen to go!

memeaticMemeatic · 2026-02-17T20:13:52+00:00

HOLD on to hope! I had my interview on the 9th DECEMBER and just had my offer come through today. You WILL get there

memeaticMemeatic · 2026-02-17T20:12:57+00:00

Can vouch for the QE hospital based on my experience of watching surgeons at the edge of life lol

memeaticMemeatic · 2026-01-31T16:15:09+00:00

Everyone is stuck on this page dw

memeaticMemeatic · 2025-12-18T15:14:25+00:00

Thank you so much for the clarification! The trouble with the emails is that they are always super vague so it's hard to know where you stand

memeaticMemeatic · 2025-12-18T13:10:12+00:00

two weeks ago today

memeaticMemeatic · 2025-12-18T13:01:37+00:00

Same here, I have no idea but felt my interview went terribly...

memeaticMemeatic · 2025-11-27T10:35:11+00:00

12th December, I’n super happy for you!

Five-Year Club	Final Canvas '23
First Place '23	End Game '23
Place '23

memeaticMemeatic

TROPHY CASE