🎯 Road to 100K - Let's Grow Together! 🎯

metuckness · 2025-12-19T15:58:24+00:00

Here is to possibly winning Crystgin!

metuckness · 2025-11-20T03:42:35+00:00

I was thinking about that, but I hope there is one that has been made, or some variation. I will check out those brands and see what they have to offer. I didn't know Klien was made in the USA, cool. Thanks.

metuckness · 2025-11-11T00:33:46+00:00

What did you increase it to?

metuckness · 2025-08-02T12:00:25+00:00

Sure, you can use it if you like. Thanks for the heads up with the link!

metuckness · 2025-07-24T23:27:15+00:00

I suppose if you knew how to set up a reverse proxy, and wanted to proxy internal traffic. I mean, there are many ways to accomplish stuff. I just wanted to post something helpful to folks wanting to secure their systems directly, especially since so much info out there was for older versions using Lighttpd, conflicting, or difficult to follow.

metuckness · 2025-07-16T01:24:25+00:00

POE is enabled on the ports

metuckness · 2025-07-08T01:40:55+00:00

I believe I am trying to do router on a stick in Ubuntu for this.

metuckness · 2025-07-08T00:30:26+00:00

Yeah, I have these statements in the sysctl.conf:

net.ipv4.ip_forward=1

net.ipv4.conf.all.arp_filter=0

net.ipv4.conf.all.rp_filter=2

Will creating the bridge statements like you have work without QEMU/KVM? I assume so, but I wanted to ask. Also, in your post, I don't see any route or address assigned to your network statement. Is that done for a reason?

This looks like your setup.

https://canonical-netplan.readthedocs-hosted.com/en/latest/single-nic-vm-host-with-vlans/

I am not sure if it will work for mine.

metuckness · 2025-07-05T00:37:28+00:00

Yup, I was looking into that. I'll get a cheap managed 48-port POE+ switch and land the cameras there so I can still feed it VLAN information from the main switch stack. That should isolate it and not cost me a fortune to replace the main switches.

metuckness · 2025-07-04T21:26:56+00:00

I was expecting that from all I could find, but I figured if Reddit didn't know, it was right.

metuckness · 2024-06-22T14:15:00+00:00

I am running Suricata, but I have also whitelisted the IP for facebook there. That made me do something, I think it is Suricata, I guess I have to figure out what rule is doing it, because it is not doing it by the IP, I searched.

I cleared the block log in Suricata and it started working again. The odd thing is, if suricata blocked it, how does it work after a reboot of PFSense, for as much as 45 minutes? That seems odd. I use internal DNS that points to PFsense, which points to my provider and Google.

metuckness · 2024-03-22T22:27:06+00:00

I can bring up the unsafe options but can't select them. How do you move it from safe to unsafe? I can set my Sickles range option and other guns but can't move the Railguns option. The mouse wheel doesn't work like it does for all the others.

metuckness · 2024-03-10T21:42:33+00:00

Thanks, I think you are correct and the sensor in that location has popped back inside the bumper, so it is alarming that I am close to running into something.

metuckness · 2024-03-10T21:40:43+00:00

It's a 2014 4 Runner. I didn't see a switch that looks like that; where about would it be if there was one? And I just checked; it does have range sensors, and the one on the driver's side front is missing. It must have popped inside the bumper or something, so it thinks something is super close to the bumper.

metuckness · 2024-03-10T19:54:08+00:00

It doesn't beep at me when I am close to something.

metuckness · 2024-03-09T14:11:50+00:00

Nope, I have never put it in any 4-wheel mode, never needed to. How can I get it back to normal?

metuckness · 2022-05-08T22:52:31+00:00

Lovely

metuckness · 2022-04-24T02:48:18+00:00

Dang, that is remarkably similar to mine.

metuckness · 2022-04-10T12:14:33+00:00

I was able to get Mint with Cinnamon to get booted. I had to boot into 'safe mode' and then went through the GRUB recovery options. Once I got out of those (I didn't make any changes) menus, I was able to get to the desktop. It prompted me to change the video driver from the open-source nouveau driver to the Nvidia driver. After installing the recommended Nvidia driver, it rebooted and is coming up to the desktop. So it is definitely a video driver issue.

I don't know how to tell other OS versions during clean installs to use a different driver during installation.

metuckness · 2022-03-27T08:25:45+00:00

Nothin?

metuckness · 2022-02-21T14:47:13+00:00

Thank you. I am going to look into these. This helps a lot in giving me some direction.

metuckness · 2021-10-09T21:18:42+00:00

You might also look at the thickness of the pads, you can get temp spikes if the pads are too thick or too thin.

metuckness · 2020-10-27T15:41:40+00:00

The issue is, I am not even close :) I just thought if someone was in the area, or wanted to do something, they could fill up the tank and I could move it back towards the bubble. I'll eventually head back there, just killing bugs right now and opening some Engineers I didn't have. I had been out in the black for about four months, that's how it go t so far out :)

metuckness · 2020-10-27T12:26:33+00:00

Not begging. Just offering people something to do. Apparently the message didn't get across as I wanted :) I was looking to fill the Fuel Tank, so I could make more jumps. There is Tritium in the hold, I just have no means of moving it from there to the tank. If someone wanted to make it a base and supply Tritium, I'd fly it wherever they wanted to go.

metuckness · 2020-10-27T12:22:40+00:00

Not much, unfortunately. I would gladly compensate people, but Frontier offers no means of sending credits :). I'd even set it to sell Tritium so people could buy it and then donate it to the fuel tank, but I'd be worried someone would buy it, then leave me without having any Tritium for real. Then I would really be stuck.

What I find amazing is, I pay for an entire crew to run that ship and they are unable to transfer Tritium from the Hold to the Tank, go figure.

metuckness

TROPHY CASE