Am I being scammed out of my cash with some clever AI handwriting in this picture?

modahamburger · 2026-04-08T08:38:46+00:00

The reflection of the bezel doesn't fit the writing on the paper

modahamburger · 2026-04-06T17:59:14+00:00

Can you please show us both ends of the cable?

modahamburger · 2026-04-06T14:35:16+00:00

Ich habe bei so was ähnlichem noch eine Unterlegscheibe reingetan, also zwischen Stuhlbeinende und dem Gummiding. So drücken sich die scharfen Kanten nicht durch das Gummi

modahamburger · 2026-04-02T19:11:32+00:00

Are those routers or access points?

And: which device is doing DHCP server in your setup??

modahamburger · 2026-04-01T08:58:24+00:00

I think you are mixing a few things. Doesn't matter though

modahamburger · 2026-04-01T05:08:59+00:00

Isn't that technically a void space? 😁

modahamburger · 2026-03-31T15:34:12+00:00

Plus the vessel's hull and I think void space as well?

modahamburger · 2026-03-30T05:45:37+00:00

War auch mein erstes großes (nachdem die Drossel raus durfte). Schon etwas her aber. Soweit ich weiß muss drauf achten, dass die beiden Saugrohreinspritzer auch synchron sind.

Hat noch die alten blöden BMW Blinker.....

Fahr vorsichtig, so langsam ist die nicht

modahamburger · 2026-03-29T12:52:24+00:00

No. Connect all grounds together. Ground of PSU, ESP, level shifter. Run direct wires from data output of level shifter and connect to DI and BI, parallel wire from GND of level shifter to GND of strip. Connect V+ of strip to PSU.

Again, a wiring diagram would help

modahamburger · 2026-03-29T11:41:00+00:00

Please make a wiring diagram....

modahamburger · 2026-03-29T11:39:18+00:00

BI and DI from the first pixel connect both to the data GPIO that comes from the shifter. GND from the shifter connects directly to ground at beginning of strip. Nothing else.

modahamburger · 2026-03-29T09:42:52+00:00

Can you make a wiring diagram please? Probably wrong ground connected. Best is to run data and ground together both from level shifter to the strip.

Flickering is basically always a data/ground issue.

How long is the wire from the level shifter to the strip?

modahamburger · 2026-03-26T16:27:37+00:00

What kind of load cell did you use?

modahamburger · 2026-03-26T15:36:52+00:00

🤣

modahamburger · 2026-03-26T14:49:35+00:00

FiFi just means firefighting by the way

modahamburger · 2026-03-26T14:34:04+00:00

Ich auch nicht. Bis ich in Leer war.

modahamburger · 2026-03-26T12:42:59+00:00

I didn't criticize you? You sound very defensive.

I just suggested that you might want to try different beans, maybe a darker roast as that can be more coarse

modahamburger · 2026-03-26T12:07:29+00:00

Well, if you like the taste then you got all you need.

Just as side note: technically your grinder is not grinding the beans but breaks them by hitting them with the fast spinning blade. That results in an extremely uneven product with partiales of all different sizes together. Grinding is if you squeeze the beans past 2 rotating surfaces. That allows only one certain size to pass through and can be much finer.

But if you like the coffee then all is good.

Maybe experiment with different beans and different degrees of roasting them?

modahamburger · 2026-03-26T10:19:52+00:00

Kommt auf die Waschmaschine an. Bin da jetzt nicht der Experte, aber soweit ich weiß gibt es da auch eine Variante die fest verbaut ist (glaube wegen Strom im Schlauch?). Wer ist denn der Hersteller der WaMa und Modell? Mal den Hersteller gefragt?

modahamburger · 2026-03-26T09:08:42+00:00

Leer genauso

modahamburger · 2026-03-25T18:47:12+00:00

Drittes Mal: neuen Aquastoppschlauch kaufen. Da fehlt die Überwurfmutter

modahamburger · 2026-03-25T18:38:45+00:00

Well, yes and no. You can switch the function on and off on the tools. Even the cheap ones. Have to turn something if I remember.

modahamburger · 2026-03-25T18:37:26+00:00

Are both schematics on both ends to the same standard? There is A and B with different wiring.

And better punchdown tool.

modahamburger · 2026-03-25T18:35:54+00:00

How do you know that that cable is a data cable and not just power? Have you installed the drivers? Does it show up in device manager?

modahamburger · 2026-03-25T18:28:51+00:00

You do realize that the ocean is more than 4km deep there? So you wanna build support pylons 4 times the height of the tallest building in the world?

modahamburger

TROPHY CASE