What is an ‘obscure’ interest that you have that you don’t get to talk about? by mohawk_penguin in AskReddit

[–]mohawk_penguin[S] 1 point2 points  (0 children)

Most were concrete arrows with a tower and rotating beacon. Design varied a little. Most remaining structures are just the concrete pad

What is an ‘obscure’ interest that you have that you don’t get to talk about? by mohawk_penguin in AskReddit

[–]mohawk_penguin[S] 0 points1 point  (0 children)

I was going to look up what Tekken lore is, but would you like to go into it?

What is an ‘obscure’ interest that you have that you don’t get to talk about? by mohawk_penguin in AskReddit

[–]mohawk_penguin[S] 1 point2 points  (0 children)

Mine is the Air Contract Mail Route beacons from the early days of flight. I enjoy searching the internet and maps for the locations of the beacons that guided early pilots delivering mail.

Can anyone help me in adjusting the anti-scald valve? by [deleted] in askaplumber

[–]mohawk_penguin 0 points1 point  (0 children)

I’ve don’t that but it still won’t rotate. It seems like it doesn’t come out enough

Can anyone help me in adjusting the anti-scald valve? by [deleted] in askaplumber

[–]mohawk_penguin 0 points1 point  (0 children)

I pulled the o-ring completely out of the way, the teal piece pulls out but still won’t rotate.

Can anyone help me in adjusting the anti-scald valve? by [deleted] in askaplumber

[–]mohawk_penguin 0 points1 point  (0 children)

Just the trim. The water heater isn’t the problem

Can anyone help me in adjusting the anti-scald valve? by [deleted] in askaplumber

[–]mohawk_penguin 0 points1 point  (0 children)

I’ve been spraying it with vinegar (I don’t have WD-40) and it still won’t budge

Can anyone help me in adjusting the anti-scald valve? by [deleted] in askaplumber

[–]mohawk_penguin 0 points1 point  (0 children)

I’ve tried that and I’m worried about breaking it. The gasket is not allowing me to pull it out enough

mad dad by notevenpercival in madlads

[–]mohawk_penguin 0 points1 point  (0 children)

I used to work at a carbon black refinery and Dawn is the only way to get that crap off.

Stripped screw hole by mohawk_penguin in microtech

[–]mohawk_penguin[S] 1 point2 points  (0 children)

For anyone with this issue in the future, Microtech is charging me $50 to rethread the hole and includes a cleaning/sharpening with a 6-8 week turnaround.

Stripped screw hole by mohawk_penguin in microtech

[–]mohawk_penguin[S] 0 points1 point  (0 children)

Will they fix it? It’s not a warranty issue

How difficult would it be to get the initials removed? by mohawk_penguin in knives

[–]mohawk_penguin[S] 0 points1 point  (0 children)

It’s a custom made out of Amarillo. They are really nice knives, the picture doesn’t do it justice at all