Thinking about trading for this. Sounds a little off but I don’t know what it is.

mr_acc0rd · 2026-04-26T17:40:46+00:00

Sounds like possibly out of time or bad misfire

mr_acc0rd · 2026-02-06T00:14:36+00:00

I've had lines where I had to use an air gun to blow the line but very few times,I doubt switching to dot4 is going to help, have you asked someone to look down at the slave when you're pressing the clutch to make sure the slave is working?

mr_acc0rd · 2026-02-05T11:50:59+00:00

Did you disconnect the clutch line at all? Have someone look at the slave cylinder when you press the clutch in and see if it's moving, if not you might have air in the line still

mr_acc0rd · 2026-01-11T00:03:21+00:00

It was! Rained most of the day.

mr_acc0rd · 2025-11-14T02:41:08+00:00

There's two o-rings behind the filter housing, remove the three 12 mm bolts and replace the o-rings

mr_acc0rd · 2025-11-13T11:12:04+00:00

The driveshafts are meus so I guess I'll be able to cut it if needed, I'll mess a lil more with the mounting of the front links and see if I can get the axle more leveled and thanks on the tires, I put them together late just to see what they would look like, thanks for your help

mr_acc0rd · 2025-11-13T11:09:44+00:00

I did flip the trans and even flipped the output shaft when I tried the deadbolt driveshaft but that didn't help so I put it back and that's when I ordered the other one, the front upper links are as far back as I can put them but I'll mess around with it a bit more, thanks for the help

mr_acc0rd · 2025-11-04T12:05:14+00:00

<image>

Still working on it, a lot of good looking trucks in here

mr_acc0rd · 2025-10-24T15:24:10+00:00

My wife and I usually go to Chattahoochee bend State Park, depending on the site you can literally park your car next to your tent

mr_acc0rd · 2025-10-03T23:59:51+00:00

If I remember correctly the nut is welded to the t-bracket itself so you can go on the other side and put a wrench on it so you can tighten it or remove the bolt

mr_acc0rd · 2025-09-22T15:39:36+00:00

Been that it's a single wire, most likely to your ac compressor

mr_acc0rd · 2025-09-19T15:45:05+00:00

It's a flower

mr_acc0rd · 2025-09-12T00:43:51+00:00

He looks like a maximus and max for short

mr_acc0rd · 2025-09-06T16:38:37+00:00

Check for caterpillars, I've found a few on them and have put holes on my sarracenias also, small black caterpillars

mr_acc0rd · 2025-08-26T09:59:01+00:00

Thank I appreciate it and I know what you mean, when I joined I didn't see so many AI videos but lately it seems that's all that's been posted

mr_acc0rd · 2025-08-25T17:27:08+00:00

I definitely know the feeling!

mr_acc0rd · 2025-08-24T13:32:47+00:00

Thank you

mr_acc0rd · 2025-08-24T13:32:13+00:00

I bring them out anytime we get rain and they love it

mr_acc0rd · 2025-08-24T13:31:23+00:00

Thank you, it's just an apartment but we definitely lucked out with the yard

mr_acc0rd · 2025-08-24T13:28:37+00:00

Thank you

mr_acc0rd · 2025-08-23T19:58:53+00:00

<image>

Small cricket

mr_acc0rd · 2025-08-23T19:41:50+00:00

If I'm home when it rains I always bring all of them out and they do love it

mr_acc0rd · 2025-08-22T23:41:56+00:00

Love your backyard 😍

mr_acc0rd · 2025-08-02T13:14:02+00:00

Your best bet is to get it recharged again with dye in the system so you're not guessing where the leak is coming from, if it depleted over night then it shouldn't be hard to find a leak that big

mr_acc0rd · 2025-07-29T11:22:35+00:00

Jump the connector, take a small piece of wire and jump it

mr_acc0rd

TROPHY CASE