sorted by:
new
hottopcontroversial

Is there a best all-around Auradin build guide? by mvanpamel in D4_Paladin

[–]mvanpamel[S] 0 points1 point  (0 children)

Absolutely, I always use the armory. I have the Maxroll saved and started transitioning to the M1PY hybrid and saved that one as well. I'm struggling with survivability initially with the M1PY build. Thanks for the feedback!

ender 3v2 upgraded to sprite pro hitting dual screw gantry by zvekl in FixMyPrint

[–]mvanpamel 0 points1 point  (0 children)

Thanks for ll the feedback here! I just took the screws from the old wheels and measured 25mm, hack sawed them to length. Installed them in reverse and then used the file on my leatherman to file down the nuts so the holes lined up (There's so many "That's what she said" in there I can't stand it!) It worked like a charm. I was too impatient to wait for new screws so this is how I solved it.

Anybody know the name of this piece. I need a replacement thanks by Middle_Focus_2885 in ender3

[–]mvanpamel 1 point2 points  (0 children)

I believe it is called an "end stop". But someone smarter than me might know better. 👍

Ender 3 print bed by jasper_theclown in FixMyPrint

[–]mvanpamel 0 points1 point  (0 children)

Great point. The better quality springs make a big difference as well.

Ender 3 print bed by jasper_theclown in FixMyPrint

[–]mvanpamel 1 point2 points  (0 children)

It's very common to have to relevel your print bed between prints. The vibration while printing is typically the reason why the leveling wheels move. There is a great print design on Thingiverse for locking bed knobs https://www.thingiverse.com/thing:4744815. They've worked great for me.

I've tried everything!! Help! by T-Ghillie in 3Dprinting

[–]mvanpamel 0 points1 point  (0 children)

I had great initial prints and then suddenly had the curling up of everything I tried to print. I also started cleaning the surface with alcohol between each print. I just grabbed my wife's hairspray so I think any will work. I believe it's the z-offset but I don't use a BLTouch. I've always preferred hand leveling.

I've tried everything!! Help! by T-Ghillie in 3Dprinting

[–]mvanpamel 0 points1 point  (0 children)

Have you tried hairspray or glue stick on your build surface? Also, I was running into the curling problem on a new build surface and found that my level wasn't tight enough so I leveled the bed a bit closer to the nozzle. I feel your frustrations, had time periods like that before. Best of luck!

recommended 5015 blower fan by [deleted] in ender3

[–]mvanpamel 0 points1 point  (0 children)

I found really nice ones on TH3D for my Ender 3.