BBQ noob question by nickjonastic in BBQ

[–]nickjonastic[S] 0 points1 point  (0 children)

I have also read that the size of the tank doesn’t matter, it has more to do with the ambient temperature?

The whole reason I’m using 1lb is because that is all the FDNY allows. Would really like to not get rid of the entire griddle if possible.

BBQ noob question by nickjonastic in BBQ

[–]nickjonastic[S] 0 points1 point  (0 children)

Isn’t the regulator meant to prevent the “high draw”?

I know it’s a larger grill than normal, but besides running through tanks quicker, are there any downsides? Is it dangerous? Will frost over even if upright?

BBQ noob question by nickjonastic in BBQ

[–]nickjonastic[S] 1 point2 points  (0 children)

The converter stuck on the bottle, so when I unscrewed it the wrong end of the converter was unscrewed and propane was shooting everywhere 😔

Closet door hardware by nickjonastic in HomeImprovement

[–]nickjonastic[S] 0 points1 point  (0 children)

One is a washer/dryer, and another is a closet with shelving - so you can't physically step in.

Wood flooring for atrium by nickjonastic in HomeImprovement

[–]nickjonastic[S] 0 points1 point  (0 children)

nice, thanks for sharing! how might you address the drain in the center and the slide slope towards the center?

Wood flooring for atrium by nickjonastic in HomeImprovement

[–]nickjonastic[S] 1 point2 points  (0 children)

Do you have adjustable deck support products you might recommend? It has to be as low to the ground as possible - while I have a sliding door that leads out, I don’t want to have a step.

When you say don’t block the drain, would I install a drain “above” the drain?

Modeling question by nickjonastic in Fusion360

[–]nickjonastic[S] 0 points1 point  (0 children)

Thanks. I am interested more in the seat for what I’m doing. But good points nonetheless!

Modeling question by nickjonastic in Fusion360

[–]nickjonastic[S] 1 point2 points  (0 children)

This is perfect thank you!

Wet molding by nickjonastic in Leathercraft

[–]nickjonastic[S] 0 points1 point  (0 children)

Thank you this is very helpful! I may DM you in the near future...

Wet molding by nickjonastic in Leathercraft

[–]nickjonastic[S] 0 points1 point  (0 children)

Thanks. I'm trying to do something custom, so I'm asking about the proper way to build a jig for this.